LEAF PRO™ EN
6
SEctiON 2
Assembly: TRIVAC®- Universal
Collection System
If your blower/vac is not a WORXTRIVAC®,
then please proceed to Section 3.
Align the arrow, on the Collection System
adapter, to the smaller Locking Peg on the
TRIVAC®vacuum outlet.Then slide the
Collection System adapater over the aligned
Locking Pegs and turn clockwise to lock,
ensuring they are fully secured. No additional
adapter is needed. (Please refer to step A1).
To remove the Universal Collection System,
simply reverse the installation steps.
SEctiON 3
Assembly: Popular Brand Models -
Universal Collection System
Black & Decker®, Poulan Pro®, Murray®,
Husqvarna®, Craftsman®, Ryobi®, andToro®.
If your blower/vac will not fit any of the
“Engineered Fit” adapters, then please
proceed to Section 4.
Please refer to the Blower/Vac Model
Adapter List in Section 1. Choose the correct
“Engineered Fit” adapter and place it into
the Vacuum Outlet shown in A2. Align the
collection system Hose Inlet with the Locking
Pegs on the adapter as shown in A2.Then
slide the Collection System adapater over
the aligned Locking Pegs and turn clockwise
to lock, ensure they are fully secured (Please
refer to step A2).
To remove the Universal Collection System,
simply reverse the installation steps.
SEctiON 4
Assembly: Other Brand Models -
Universal Collection System
Other Brand Models – Choose the “Universal
Fit” adapter (5) and place it onto the Vacuum
Outlet. Please refer to step B1-B5
1. Place the fabric side of the Universal
Adapter over the Vacuum Outlet and slide it on
as far as possible (B1)
2. Check to make sure the strap is threaded
through the locking mechanism. Then pull to
tighten the strap (B2). Increase the tension
by pulling the latch up and down to tighten
(B3). To loosen, simply press the two outside
latches down and then pull the strap out from
other side (B4).
3.Test that the Universal Adapter will not slide
off of the blower/vac outlet
4. If further tightening is needed, then pull the
middle latch up and down until the adapter is
tight. Please recheck if it will slide off of the
blower/vac outlet (B3). Realign and repeat
these steps if needed. To loosen, simply press
the two outside latches down and then pull
the strap out from other side. (B4)
5. Slide the Collection System adapter over
the aligned Locking Pegs and turn clockwise to
lock, ensure they are fully secured(Please refer
to step B5).
Please note:The Universal Adapter may have
space between the Vacuum Outlet and Adapter
Outlet after installation.
To remove the adapter, simply press the two
outside latches down and loosen the strap to
remove it from the Vacuum Outlet (B4).
SEctiON 5
Assembly: Container Installation -
LEAF PRO™ Universal Collection
SEctiON 6
SPECIFICATIONS
- 8 ft hose with up to 16 ft of surrounding
reach
- 4 factory fit connectors + 1 universal
connector fits all major brand blower/vacs up
to 5” in diameter
SEctiON 7
TROUBLESHOOTING (WA4054)
If you are having a hard time keeping
the cover on the trash can please try the
following: Cut a notch between the handle and
trash can rim to create a grove for the cover
to rest in.
