Ratings
The Appliance Module can be used to control
an incandescent lamp rated up to 500W.
X10 Wireless Technology, Inc. Limited One Year Warranty
X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10
products to be free from defective material and workmanship for a period of
one (1) year from the original date of purchase at retail. X10 agrees to repair
or replace, at its sole discretion, a defective X10 product if returned to X10
within the warranty period and with proof of purchase. If service is required
under this warranty:
For help or more information on setup, please visit:
http://www.x10.com/support
AM486/AM466-11/02
Check Out our Web site at:
http://www.x10.com
For more information on X10 products and
special promotional offers.
Setting The Module’s Code
Using a small screwdriver, set the red
House Code dial to the same letter as your
Controllers. Set the Black Unit Code dial to
any unused number.
UNIT CODE
DIAL
HOUSE CODE
DIAL
3. Plug the Module into
the same wall outlet as
your controller (see
testing below).
2. Plug an appliance
into the Module.
1. Set the House Code
and Unit Code.
It can also control other types of lamps such as fluorescent or energy saving
lamps, low voltage lamps, or lamps that include a dimmer control. And of course
it can be used to control appliances. Caution: Observe the ratings on the label
on the back of the Appliance Module.
Testing The Module
Make sure the appliance’s switch is on. Plug the Module into the same wall
outlet as your controller, press the On and Off buttons on the controller that
correspond to the Unit Code setting on the Module. If the Module turns on and
off you can unplug the Module or Controller and move it to its permanent
location. If you can’t control the module, visit http://www.x10.com/support
for help.
ApplianceModulesAM486(2pin)andAM466(3pin)
