Xblue Networks SP-9598 User manual

SP-9598 Product Appearance
SP-9598
Contents
- SP-9598
- 5V/2A Power Adaptor
- USB TypeC Cable
- QIG
- 360oCamera with Stand
6
1
2 3
4
5
1. DC Jack
2. Link to PC USB Port
3. Link to Camera Port
4. Link to Ethernet Cable (Not use)
5. Reset Button
6. LED Indication
1 2
Copyright © 2023 XBlue. All rights reserved.
Specifications are subject to change without any
notice.
SP-9598
360
o
USB Video Conference Speakerphone
[ Quick Installation Guide ]
FAQ :
1. The USB cable of SP-9598 is plugged into the
computer, but the LED does not light up?
Q1: It needs to take 15 seconds.
Q2: If the LED still does not light up after 15
seconds, please check the USB cable, to make
sure the type C end is correctly connected to
the "Link to PC USB port” of SP-9598. Please
refer to “Product Appearance” in page 2.
Q3: If the USB cable is installed correctly and the
LED is still not on, it means the computer
cannot supply enough power to the
SP-9598. Please connect the DC
power adaptor included in the gift box.

General Function
When properly connected to the computer, the speaker
and microphone can be used directly without installing
additional drivers. When the computer is connected to
SP-9598, the computer must support UAC protocol;
when connected to SP-9598, the computer must support
UAC and UVC protocol”. (*Note 2)
SP-9598 Microphone Mute Setting
Tap the upper button to toggle between mute/unmute.
When muted, the LED indicator shows a steady red light.
Volume Up / Down
Lightly press the button +: Volume Up, the red light
flashes once when pressed
Lightly press the button -: Volume Down, the red light
flashes once when pressed
MIC
MIC
Volume
Up
Volume
Down
MIC
Mute
MIC MIC
Installation
Connect the 5V/2A DC power adaptor to the SP-9598's
power connector, and connect the USB cable type C end
to the SP-9598 "Link PC USB port" and the other end to
the computer's USB jack. The LED indicator shows blue
and green lights interactively flashing slowly, indicating
that the SP-9598 has been connected to the computer.
Note :
1. If there is only power supply and no connection to the
computer,The LED indicator will show solid blue light
until it is properly connected.
2. When the USB Speakerphone is connected to the
computer, Windows should automatically be set as the
default audio device. To manually select SP-9598 as
the default audio device, do the following
(take Windows 10 as an example):
(1) Start Windows control panel
(2) Select System Audio
(3) Output device (Speaker): SP-9598 Audio
(4) Input device (Microphone): SP-9598 Audio
(5) Input device (Lens): SP-9598
3. The microphone on the lens/camera is default to mute
(LED red).
43 5 6
Lens/Camera Selection Six Mode
Free screen mode
Touch bar to select
participants
Single Host Mode
Tilt the Camera to the
forward position
Single View Mode 90oSingle View Mode 120o
Touch bar to select
Participants
Dual Host Mode
360o panoramic mode
Note1: RJ45 port is only for debug management
use, there is no special function in operation.
Note2: UAC means USB audio class transmission
protocol. UVC means USB video class
transmission protocol.
Camera
MIC
On/Off
Mode
Selection
LED Indication
(Red : MIC Off)