Xerox PHASER 340 Configuration guide

Cleaning for light stripes: printhead
Approximate time to complete: 3-10 minutes
If your prints have 1/10 in. (2.5 mm) lengthwise stripes that are the wrong
color or have missing colors, you can correct the problem by cleaning the
printhead. The printer automatically executes a printhead cleaning
sequence when you run the
Clean:Light Stripes routine from the front
panel.
1. When the printer is on and the Ready message appears, press the
Clean button. The printer displays the first selection in the menu:
Clean:Light Stripes
<---- Clean Test
2. Press the Clean button once again.
3. A series of front panel messages indicate the condition of the
printer as it progresses through a sequence of automatic cleaning
routines. The printer outputs a cleaning page at the end of the
cleaning sequence that you may discard as normal office waste.
4. When the cleaning sequence is completed, the printer displays the
following message:
Clean:Light Stripes
<---- Clean Test
9101-48A

5. To confirm that the problem has been corrected, press the Test
button to print a test page. Check for any missing color bars on
the test page.
1. Black
2. Cyan
3. Magenta
4. Yellow
9101-49
1234 678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455565758596061626364656667686970717273747576777879808182838485868788
5
1
2
3
4
678910111213
12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455565758596061626364656667686970717273747576777879808182838485868788
12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455565758596061626364656667686970717273747576777879808182838485868788
12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455565758596061626364656667686970717273747576777879808182838485868788

6. If one or more of the color bars are still missing, repeat the
cleaning sequence by pressing the
Clean button once again.
When cleaning ends, the printer outputs a cleaning page that you
may discard as normal office waste.
If the second cleaning sequence does not cure the light stripes or
missing colors problem, you can press the
Clean button for a
third time to repeat the cleaning sequence.
7. If your prints still have color stripe problems after the third
cleaning sequence, service may be required.
8. Return the printer to normal operation by pressing the button.
Source: 070-9101-03 C4
ExitExit