Xtracycle RFA User manual

Swoop assembly Manual
-
-
RFA assembly Manual
28mph

2
Tools needed
- 3 mm Allen wrench
- 4 mm Allen wrench
- 5 mm Allen wrench
- 6 mm Allen wrench
- Snippers / scissors
- 10 mm socket wrench
- Pedal wrench or 15 mm wrench
- Bicycle grease
Assembling the rfa

3
Look over the box for signs of shipping damage. If
damage is present, please take pictures in case a
shipping damage report needs to be filed.
prebuild check

4
Record the serial number and the Shimano key
number, which can be found on the label on the side
of the box. Keep these numbers in a secure place
since they might be needed in case something
happens to your bike or you lose your Shimano key.
The serial number is directly beneath the bar code
next to "Frame No:". For the RFA, this will start with
RFA. The key number is directly beneath the bar code
next to "Key No:".

5
Inspect the contents and again look for any signs of
shipping damage.
open the box

6
Remove and set aside:
- front wheel and fender (in largest box together)
- RFA KickBack and footrests (in medium box together)
- small parts box

7
If you have a stand, please secure the bike to the
stand, otherwise with a friend, lift the bike out of
the box and set it on your work surface.

8
Remove the battery keys secured to the cables in
front of the handlebars.
Charge the battery

9
Cut the zipties securing your handlebars to your
frame and place them safely to the side. Unlock
your battery and remove it by rotating it away from
the bike.

10
Find the battery charger and domestic power cable
in the small parts box. Locate the charging port on
the drive side of the battery. Pull back the rubber
cover and plug in the charging cable.