Xtracycle Swoop 4ST1000 User manual

-
Swoop assembly Manual

2
Tools needed:
3 mm Allen wrench
4 mm Allen wrench
5 mm Allen wrench
6 mm Allen wrench
Snippers / scissors
10 mm socket wrench
Pedal wrench or 15 mm wrench
Bicycle grease
assembling the swoop

3
Look over the box for signs of shipping damage. If
damage is present, please take pictures in case a
shipping damage report needs to be filed.
open the bike box

4
Record the serial number and the Shimano key
number which can be found on the label on the
side of the box. Keep these numbers in a secure
place since they might be needed in case somethig
happens to your bike or you lose your Shimano
key. The serial number is the number under the
bar code next to "Frame No:". For the Swoop, this
will start with SWP (the barcode show here is for a
Stoker). The key number is the number under the
bar code next to "Key No:".

5
Open the box.

6
Inspect the contents and look again for any signs of
shipping damage.

7
Remove and set aside the small parts box, the
KickBack 3, the wheel/fender, the u-tubes, and the
seat with post.

8
With a friend, lift the bike out of the box and set
it on your work surface. Or place in a stand, if you
have access to one.

9
Charge the battery
Remove the battery keys secured to the
handlebars.

10
Unlock your battery and remove it by rotating it
away from the bike.

11
Find the battery charger and domestic power cable
in the small parts box. Locate the charging port on
the drive side of the battery. Pull back the rubber
cover and plug in the charging cable.

12
Make sure the charge indicator lights begin to blink
green. A full charge will take a few hours but you will
be able to use the battery with a partial charge by
the time you are done setting up your bike.

13
Remove the KickBack3 packaging and locate the
included hardware kit consisting of two U-bolts, a
rectangular mounting plate, four M6 washers & nuts,
and an M5 set-screw.
install the kickback 3

14
Under your bike find the kickstand mounting shelf
and the threaded set-screw hole.

15
Rest the back of the kickstand mounting plate on
the mounting shelf and use a 3 mm Allen wrench
to thread the M5 set screw in order to hold the
kickstand in place.

16
Install the first U-bolt on the drive side of the bike.
Fit an M6 washer and nut onto the forward threads,
until just finger-tight. Place a nut on the other end
of the U-bolt, and secure to finger tight.

17
Place the second U-Bolt on the non-drive side and
position the small mounting mounting plate in
place on the forward threads. Secure it with an M6
washer and nut.
Secure the other end of the U-bolt with the
remaining M6 nut.

18
Go back to all four nuts and tighten everything with
the 10 mm socket tool.
*Just to recap, the two forward M6 nuts get washer, where as the
rear two are just the M6 nyloc nuts.

19
Install the front fender & wheel
Carefully lift the front of the bike and deploy the
kickstand.
* You may want to add something weighted to the rear rack to keep
the bike from tipping forward.

20
Remove the packaging around the fork and fender.
Remove the thru-axel with a 6 mm Allen wrench.