Xtracycle STOKER User manual

Swoop assembly Manual
RFA assembly Manual
-
stoker assembly Manual

2
Tools needed
- 3 mm Allen wrench
- 4 mm Allen wrench
- 5 mm Allen wrench
- 6 mm Allen wrench
- Snippers / scissors
- 10 mm socket wrench
- Pedal wrench or 15 mm wrench
- Bicycle grease
Assembling the Stoker

3
Look over the box for signs of shipping damage. If
damage is present, please take pictures in case a
shipping damage report needs to be filed.
Prebuild check

4
Record the serial number and the Shimano key
number, which can be found on the label on the side
of the box. Keep these numbers in a secure place
since they might be needed in case something
happens to your bike or you lose your Shimano key.
The serial number is directly beneath the bar code
next to "Frame No:". For the Stoker, this will start with
STK. The key number is the directly beneath the bar
code next to "Key No:".

5
Open the box and inspect the contents and again
look for any signs of shipping damage.

6
Remove and set aside:
- the small parts box
- the KickBack 3
- front wheel and fender
- u-tubes
- saddle with post.

7
If you have a stand, please secure the bike to the
stand, otherwise with a friend, lift the bike out of
the box and set it on your work surface.

8
Remove the battery keys secured to the handlebars.
CHARGE THE BATTERY

9
Unlock your battery and remove it by rotating it away
from the bike.

10
Find the battery charger and domestic power cable in
the small parts box. Locate the charging port on the
drive side of the battery. Pull back the rubber cover
and plug in the charging cable.

11
Make sure the charge indicator lights begin to blink
green. A full charge will take a few hours but you will
be able to use the battery with a partial charge by the
time you are done setting up your bike.

12
Remove the KickBack3 packaging and locate the
included hardware kit consisting of two U-bolts, a
rectangular mounting plate, four M6 washers & nuts,
and an M5 set-screw.
Install the KickBack 3

13
Under your bike find the kickstand mounting shelf and
the threaded set-screw hole.

14
Rest the back of the kickstand mounting plate on the
mounting shelf and use a 3 mm Allen wrench
to thread the M5 set screw in order to hold the
kickstand in place.

15
Install the first U-bolt on the drive side of the bike. Fit
an M6 washer and nut onto the forward threads, until
just finger-tight.
Place another washer and nut on the other end of the
U-bolt, and secure both nuts with a 10 mm socket
tool, being mindful to tighten each end of the U-bolt
evenly.

16
Place the second U-Bolt on the non-drive side and
position the small mounting mounting plate in place
on the forward threads.
Secure it with an M6 washer and nut. Secure the other
end of the U-bolt with the remaining M6 washer and
nut.

17
Go back to all four nuts and tighten everything with
the 10 mm socket tool.

18
Carefully lift the front of the bike and deploy the
kickstand.
* You may want to add something weighted to the rear rack to keep the
bike from tipping forward.
Install the front fender

19
Remove the thru axle with a 6mm hex wrench.

20
The hardware for you fender is already installed
in your fork. Please remove the M6 nyloc nut and
L-bracket.