Yaesu GB7MT Manual

V1.0 22/07/2019 KB
Configure the Yaesu FTM-100DE for GB7MT Technical
Information
Yaesu UK Limited
Unit 12 Sun Valley Business Park, Winnall Close, Winchester, Hampshire, SO23 0LB
1) Please make sure that your callsign has been entered in your radio. If not, please refer the Operator Manual.
2) Enter the output frequency of GB7MT 439.6625MHz
Make sure the radio is in VFO mode
.
Press to toggle between VFO and
Memory mode.
Using the num
ber keys on the microphone
type in
[4] [3] [9] [6] [6] [2]
The frequency 439.66250 is displayed on the
screen.
3) Set the mode to C4FM.
Press the button until above the
mode indication is displayed. This will put
the radio is AMS mode, the radio will
automatically switch between DN, VW or
FM.

V1.0 22/07/2019 KB
Configure the Yaesu FTM-100DE for GB7MT Technical
Information
Yaesu UK Limited
Unit 12 Sun Valley Business Park, Winnall Close, Winchester, Hampshire, SO23 0LB
4) Setup the repeater shift frequency
Press for one second or longer.
The Setup Menu will be displayed.
Rotate the DIAL to select [8 CONFIG].
Press .
Rotate the DIAL
to select
[5 R
E
P
EA
T
ER
SHIFT]
Press .
Rotate the D
IAL to select
[
2
–
REPEATER]
Press .
Rotate the DIAL
to select
[
6
R
E
P
EA
T
ER
SHIFT
FREQ]
Press .
Rotate the DIAL until the repeater shi
ft
frequency is 9.000MHz.
Press and hold for over one second to
store the settings.

V1.0 22/07/2019 KB
Configure the Yaesu FTM-100DE for GB7MT Technical
Information
Yaesu UK Limited
Unit 12 Sun Valley Business Park, Winnall Close, Winchester, Hampshire, SO23 0LB
5) Store the repeater frequencies into a memory channel.
Press and hold Press
MEMORY WRITE is displayed on the screen.
To specify a memory channel name please
refer to “Naming a memory channel” on page
56 of the operator manual.
Rot
ate the
DIAL to s
elec
t the desired mem
ory
channel.
Press to store the repeater frequencies
into the memory.
The radio displays the frequency and memory
channel.
Press to toggle between VFO and
Memory mode if required.