Yakima LockNLoad Mk2 User manual

6100003631-Rev0.2 1/2
FIXED AND TRACK MOUNT KITS
®LockNLoad Mk2 Leg Kit Instruction
THESE INSTRUCTIONS SUPPLEMENT
THE BAR/LEG INSTALLATION
SECTIONS THAT MAY STILL
FEATURE THE MK1 LEG IN YOUR
VEHICLE FIXED OR TRACK MOUNT
FITTING KIT INSTRUCTION
BAR INSTALLATION
INSERT LEGS
Slide the pre-assembled Leg assemblies into the
underside channel of LockNLoad Bars.
If Leg assemblies will not slide in,
loosen Screws to increase gap.
1
Note: Nut Plates
are not required.
LEVEL BARS - FIXED POINT
With vehicle on a level surface, adjust all
Bar angles to be level using a Spirit Level.
The Bar angle can be adjusted to reduce
any wind noise. In most cases this is
achieved by getting the Bar in-line
with air low parallel to the ground.
2
Air Flow
SECURE LEGS TO BARS
Tighten all M8 Set
Screws to 9 Nm using
a 13 mm Spanner.
3

6100003631-Rev0.2 2/2
Disassemble Leg
components as
shown and store
in a safe place.
2
REMOVE LEG
COVERS
Using the keys
supplied in the
LockNLoad Leg Kit
(sold separately),
remove all Leg
Covers.
1DISASSEMBLE LEG
ASSEMBLIES
ASSEMBLE LEGS
Assemble each Leg as shown using
one Platform Mount Bracket, M8
Coach Bolt and M8 Nut from the
LockNLoad Leg Kit.
All Brackets should be parallel
with the base of the Leg prior to
tightening.
Tighten all M8 nuts to 9 Nm
using a 13 mm Spanner.
3
PLATFORM LEG MOUNTING INSTRUCTIONS