Yakima PlateMate User manual

®
PlateMate Installation
ITEM COMPONENT QTY
1. Back Plate x1
2. Knurled Nuts x2
3. Screws x2
4. Velcro Straps x3
• Please read instructions carefully before installation.
• Check the contents of kit. Contact your YAKIMA
dealer if any parts appear missing or damaged.
• Place these instructions in the vehicle’s glove box
after installation is complete.
FIRST TIME INSTALLATION
INSERT VELCRO STRAPS
Take x2 Velcro Straps and
thread through the front of
PlateMate as shown.
1
Pull Velcro Straps completely
through as shown.
1
2
3
4
NOTE:
Strap coniguration
shown is for Yakima
HoldUp.
PlateMate can
also be attached
to other carriers
using the other slot
combinations.
KIT CONTENTS
6100003124-Rev2
POSITION NUMBER PLATE
Position your number plate onto the
PlateMate. Using the x2 Screws,
line up the Screws through slots
in your number plate with the
appropriate holes in PlateMate.
2
SECURE NUMBER PLATE
Turn PlateMate over carefully
ensuring that the screws don’t
fall out. Spin the Knurled
Nuts onto screw threads.
Finger tighten nuts until number
plate is secure on PlateMate.
3
6100003124-Rev2

ATTACH PLATEMATE
Attach your assembled PlateMate
to your bike carrier using the 2x
Velcro Straps as shown below.
4
The remaining Velcro Strap
can be threaded through one
of the lower slots in PlateMate
to prevent swinging if you opt
to attach PlateMate to the
rearmost bicycle on the carrier.
www.yakima.com.au
YAKIMA AUSTRALIA PTY. LTD
17 Hinkler Court
Brendale, QLD 4500
Australia
1800 143 548
6100003124-Rev2
079YA K
BIKE RACK NUMBER PLATE
6100003124-Rev2