YOODA MAGNETIC Deluxe-15Rw User manual

1. Control:
can control single motor, or a group
of up to 20 motors on each channel
2. Range:
200 meters outdoor,
35 meters indoor
3. Battery:
CR2430
4. Power supply:
3 V
5. Dimensions:
86 x 86 x 14 mm
6. Transmitting power:
10 mW
7. Operating temperature:
0°C + 50°C
8. Protection degree:
IP 30
Radio receiver range is a variable value and can differ from declared values depending on conditions in which device
operates. Possible sources of changes in range are building construction, interference caused by other radio transmitters
etc.
In order to fully explore available functions of MAGNETIC Deluxe series please take a moment and read this manual before using the device.
MAGNETIC Deluxe transmitters are compatible with all YOODA brand devices.
MAGNETIC Deluxe_15Rw
www.sukcesgroup.pl
1. General information
2. Detailed description
1
Illustrations (from the top):
Fig. 1. 15-channel MAGNETIC Deluxe remote control black (MAGNETIC Deluxe_15Rw_B)
Fig. 2.15-channel MAGNETIC Deluxe remote control, white (MAGNETIC Deluxe_15Rw)
15-channel transmitter
(front)
15-channel transmitter
(back)
UP button
STOP button
battery
DOWN button
CHANNEL + buttonCHANNEL - button
ZERO button

1. Pushing simultaneously ZERO and CHANNEL+ - has the function of P2 programming button
2. When you press the ZERO button, the digit 0 will appear, which indicate the group channel. On this channel, all the
devices programmed for each channel of the transmitter are active. On the group channel we do not perform any
programming procedures
3. Estimated battery lifespan is 3 year if the device runs 4 commends a day in average.
4. Batteries should be changed when no channel number is displayed after pressing any button or receiving device stops
reacting to commands.
5. Batteries contain substances that may be hazardous to health and may pollute the environment. Used batteries should
be disposed of properly.
Pressing UP or DOWN button exits active channel selection mode.
Repeat the following procedure to set the number of active channels.
3. Active channel selection
2
1. Way of programming first transmitter depends on type of radio receiver. When programming first transmitter please
follow instruction of the device that is going to be controlled by the transmitter.
2. Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
3. Programming transmitter using this ethod will result in deleting receiver memory.
Turn on power supply
or press microswitch
(for 2 sec.) when
power is on.
Motor will make a sound.
Roller shutter will make
an up/down move.
Motor will make a sound.Press simultaneously
ZERO and CHANNEL+
buttons.
or
Roller shutter
will make an
up/down move
and the motor
will make a few
short sounds.
Motor will make a sound.Press simultaneously ZERO +
and CHANNEL+ buttons.
Press UP button.
4. Programming first transmitter to R-type motors
Press simultaneously and hold down the CHANNEL +
and CHANNEL- buttons. "C" symbol appears on the display
and than after 4 seconds it changes to number 15 with up
and down arrows.
Use the CHANNEL + or CHANNEL - buttons
to set the number of displayed channels.
Press the STOP key to conrm your choice.
The symbol "o" should appear.