Zennio GetFace IP ZVP-CB3M User manual

GetFace IP
Surface installation - Frame - 3 modules
ZVP-CB3M Assembly instructions
© Zennio Avance y Tecnología S.L. Ed. 1 For more info www.zennio.com Page 1/ 2
ASSEMBLY OF THE FRAME (ONE-COLUMN LAYOUT)
1 Please remove the blind panels and the additional modules. After
that, assemble the additional module enclosures, opening the gaps
previously. Then fix the assembly by using the supplied parts and
screws. Place the metallic auxiliary parts supplied with the frame. Move
the microphone to the lower enclosure.
2 Place the basic unit correctly leveled on the wall and drill two holes
for the expanding plugs. Recover the cables and fix the module with the
screws (included).
3 Connect the cables to the basic unit and interconnect the additional
modules with the bus as shown in the schema.
4 Fix the blind panel and additional modules that remain in sight with
supplied screws and put the labels with captions next to the buttons.
5 Place the frame. 6 Fix the frame using by the supplied Allen key.
Note: it is recommended to install the backplate (ZVP-BPLA3) if the wall surface irregularity is greater than 0.5mm.

© Zennio Avance y Tecnología S.L. Ed. 1 For more info www.zennio.com Page 2/ 2
ASSEMBLY OF THE FRAME (MULTIPLE-COLUMN LAYOUT)
1 Please remove the blind panels and the additional modules. After
that, assemble the additional module enclosures by opening the gaps
previously. Then, fix the assembly by using the supplied parts and
screws. Place the metallic parts supplied with the frame. Move the
microphone to the lower enclosure.
2 Place the left assembly correctly leveled on the wall and drill two
holes for the expansive plugs. Recover the cables, place the bus and fix
the left assembly with the screws (included).
3 Place the right assembly on the wall by using the T-shape parts.
Mark the position of the holes, drill them and afterwards place
expansive plugs inside.
4 Fix the right assembly to the wall with screws. Make the
connections of the basic unit and prepare the additional modules. Pass
the bus cable through the gaps.
5 Interconnect the additional modules with the bus as indicated in the
schema and then fix the additional modules with the screws.
6 Place the frames and fix them by using the supplied Allen key.
Note: it is recommended to install the backplate (ZVP-BP2W3H, ZVP- BP3W3H) if the wall surface irregularity is greater than 0.5mm.