Zennio ZVP-CB2M User manual

GetFace IP
Surface installation - Frame - 2 modules
ZVP-CB2M Assembly instructions
© Zennio Avance y Tecnología S.L. Ed. 1 For more info www.zennio.com Page 1/ 2
ASSEMBLY OF THE FRAME (ONE-COLUMN LAYOUT)
1 Please remove the blind panel of the basic unit and place
the metallic auxiliary parts supplied with the frame.
2 Place the basic unit correctly levelled on the wall and drill
two holes for the expanding plugs. Recover the cables and fix
the module with the screws (included).
3 Connect the cables to the basic unit and interconnect the
additional modules with the bus.
4 Fix the blind panel (or additional modules that remain in
sight) with the supplied screws and put the labels with captions
next to the buttons.
5 Place the frame. 6 Fix the frame by using the supplied Allen key.
Note: it is recommended to install the backplate (ZVP-BPLA2) if the wall surface irregularity is greater than 0.5mm.

© Zennio Avance y Tecnología S.L. Ed. 1 For more info www.zennio.com Page 2/ 2
ASSEMBLY OF THE FRAME (MULTIPLE-COLUMN LAYOUT)
1 Please remove the blind panels and the additional
modules. After that, assemble the additional module enclosures
by opening the gaps previously. Then, fix the assembly by using
the supplied parts and screws. Place the metallic parts supplied
with the frame.
2 Place the left assembly correctly levelled on the wall and
drill two holes for the expansive plugs. Recover the cables and
fix the module with the screws (included).
3 Place the right assembly on the wall by using the T-shape
parts. Mark the position of the holes, drill them and afterwards
place an expansive plug inside them.
4 Fix the right assembly to the wall with screws. Make the
connections of the basic unit and prepare the additional
modules. Pass the bus cable through the gaps.
5 Interconnect the additional modules with the bus as
indicated in the schema and then fix the additional modules with
screws.
6 Place the frames and fix them by using the supplied Allen
key.
Note: it is recommended to install the backplate (ZVP- BP2W2H) if the wall surface irregularity is greater than 0.5mm.