Zimmer Cryo 6 User manual

1
Mounting of the Holder Arm for Treatment Tube
After assembly, the device should appear as indicated in Figure 1 below.
Figure 1
Rod
Support bracket
Grommet
Articulated oint

2
Assembly Instructions:
1. Necessary parts:
Figure 2
1 Support bracket
2 Rod
3 Hose holder
4 Articulated joint
5 Hook
6 2 screws M5x25 and an allen ke
2. Before starting, please assemble the glass plate onto the Cryo V6.0 as indicated
in the User Manual Cryo V6.0 (Chapter 2 “Assembly Instructions”)
3. Then insert the 2 grommets as indicated below (see Figure 3 ).
Figure 3
Grommet 1
Grommet 2
4
3
2
1
5
6

3
4. Next, use the allen key and screw the support bracket to the bottom of the Cryo V6.0
(threads are already inserted into the device bottom).
Figure 4
5. Now, push the rod through the hole in the glass plate ( Figure 5 ) and snap it into the snap-on
connection on the support bracket (Figure 6).
Figure 5
Figure
Threads

4
6. Screw the articulated oint onto the rod.
7. Then screw the hose holder onto the articulated oint.
8. Hang the hook onto the articulated oint.
Figure 7