ZKTeco FHT2300 User manual

Full Height Turnstile
User Manual
Applicable Models: FHT 2300 / 2400
Version: 1.2 Date: Mar. 2019

1
Contents
Chapter 1 Product Introduction .................................................................................................... 1
1.1 Model number and access control ................................................................................ 1
1.2 Structures and dimensions ............................................................................................. 1
1.3 Mechanical system of FHT2300&FHT2400 series ..................................................... 2
1.4 Electronic control system ................................................................................................ 2
1.5 The working principle of full height turnstiles ............................................................... 3
1.6 Product related parameters ............................................................................................ 3
Chapter 2 The Installation of the Device ..................................................................................... 4
2.1 Installation notes .............................................................................................................. 4
2.2 Installation position of the full height turnstile .............................................................. 4
2.3 Installation and fixation of cables .................................................................................. 4
Chapter 3 Product Maintenance .................................................................................................. 8
3.1 Mainframe-box maintenance ......................................................................................... 8
3.2 Movement maintenance ................................................................................................. 8
3.3 Power maintenance ......................................................................................................... 8

1
Chapter 1 Product Introduction
1.1 Model number and access control
Access
Model
No C3-200 with two KR101E
reader
InBio260 with two FR1200/ID
reader
FHT2300 √
FHT2311 √
FHT2322 √
FHT2400 √
FHT2411 √
FHT2422 √
1.2 Structures and dimensions
FHT2000 series has stainless steel casing, which provides corrosion resistance and
durability.
FHT2300’s appearance and dimensions are as shown in Figure 1-2A：
Figure 1-2A

2
FHT2400’s appearance and dimensions are as shown in Figure 1-2B：
Figure 1-2B
1.3 Mechanical system of FHT2300&FHT2400 series
The mechanical system of the full height turnstiles includes a mainframe box and a frame.
The direction indicator, core, control panel, access controller and lock are installed in the
mainframe box. The core component mainly consists of two solenoids, a spring and a
transmission mechanism. The frame supports the entire mainframe box.
1.4 Electronic control system
The electronic control system of the full height turnstile is composed of reader, control
panel, access controller, direction indicator, horn, and transformer.
Reader: The reader reads the data from the card and sends it to the controller.
Control panel: The control panel is the system’s control center that receives signals from
the controller. After the signals have been processed by the control panel, the control panel
will deliver commands to the indicator. .
Direction indicator: This indicator displays the current status of the sign at the channel, and
directs the pedestrian to pass the channel.

3
1.5 The working principle of full height turnstiles
1.5.1 After the power is turned on, the system will perform self-check. If no fault is detected,
the device will operate as usual. If a fault is detected, the system will display the related
messages on the LCD screen. This can be useful for error checking and troubleshooting.
1.5.2 When the reader detects a valid signal, the buzzer will give pedestrians a voice
prompts to remind pedestrians have been successful credit card. And then, the reader
sends signals to the access controller to request permission to pass through the passage.
After the access controller send the signals to the control panel, the control panel will send
out a pass.
1.5.3 After receiving the signal from the access controller, the control panel sends signals
to the direction indicator and solenoid. Then the direction arrow will turn green. Also the
solenoid will loose that the pedestrian can push the rod to pass the passage.
1.6 Product related parameters
Dimensions(mm) FHT2000: L = 1400, W = 1310, H = 2200
FHT2400: L = 1400, W = 1370, H = 2200
Communication
Interface RS232 Input voltage
AC 100 - 120V/200 - 240V,
50 - 60Hz
Input control signal Switching
signal
Output
voltage DC 24V
Working
environment Indoor/Outdoor
Relative
humidity 25% - 75%
Temperature -28℃~ 60℃ Pass speed
RFID：Maximum 30/minute
Fingerprint：
Maximum25/minute
Face：Maximum 15/minute
Vein：Maximum 15/minute

4
Chapter 2 The Installation of the Device
2.1 Installation notes
2.1.1 It is recommended that the full height turnstile should be installed on a cement
platform with 50mm to 100mm in height.
2.1.2 It is recommended that the full height turnstile should not be used in corrosive
environments.
2.1.3 Make sure the earth wire of the system is connected reliably reliably to prevent any
personal injuries or other accidents.
2.1.4 After completion of the installation, check the connection condition of earth wire,
connector assembly for connecting line and all moving parts with the device. Make sure
the connection is firm in order to prevent failure caused by long time operation. If any screw
or part is not tightened, please tighten.
2.2 Installation position of the full height turnstile
The installation position are subject to the size of the full height turnstile, as shown in Figure
2-2A.
Figure2-2A
2.3 Installation and fixation of cables
The following diagram shows the interface of the concealed cable. The input voltage for

5
this full height turnstile is AC100-120V/200-240V. The PVC conduits are buried 100mm
below the ground, with the height of the exposed part not not less than 100mm. To prevent
water leakage to the conduit, the conduit mouth needs to be bent back.
FHT2300&FHT2400 series installation holes are as shown in Figure 2-3A and Figure 2-3B.
Figure2-3A
Figure
2
-
3B
Ø25 PVC pipe
Ø25 PVC pipe

6
Put the installation diagram on the floor. Using percussion to drill holes for M12 screws
on the corresponding position. Then install the screws to the corresponding positions.
Next, place the frame on top of the screw and fix it. After that, the mainframe-box is fixed
on the frame. Finally install the whole rotating part in the middle of the frame as shown in
Figure 2-3C.
Figure2-3C
After fixing the device, open the mainframe-box to connect power wire and reader. Pull out
the reader and power cord from both sides of the column and connect to the corresponding
interface. Wiring diagram is as shown in Figure 2-3D
1
2
3
3
4

7
Figure 2-3D

8
Chapter 3 Product Maintenance
3.1 Mainframe-box maintenance
The mainframe-box is made of 304 stainless steels. So after a long period of operation, its
surface may have some stains. It can use gauze to clean the mainframe-box. In order to
protect the lines of surface, please wipe along the lines direction. It's best to polish and
wax.
3.2 Movement maintenance
Cut off power supply before maintenance. Open the barriers and clean the dust on surface,
add lubricating oil to the transmission mechanism. Check and tighten others
connection parts.
3.3 Power maintenance
Cut off power supply before maintenance. Check whether the plug is loose, if loose, it
needed to tightly it. Please do not replace the connection position at random. Check
whether the external power supply is exposed and wrap it. Check whether there is any
leakage, found to be timely processing. Check the technical parameters at the interface
are regular and replace the old electronic components in time.
（Attention: Above full height turnstile maintenance must be maintained by professional
personnel. Especially the movement and the electric control part, first cut off the power
supply, ensure the operation safety.）