ZKTeco Mars-S1011 User manual

Installation Guide
Mars-S1000 Series/Mars Pro-S1000 Series
Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the
actual product and the written information in this manual.
Version: 1.0
Applicable Models: Mars-S1000/1011/1022/1200/1211/1222
/Mars Pro-S1000/1011/1022/1200/1211/1222

It is recommended that the swing barrier turnstile must be installed on a horizontal solid platform
with a height of 50mm to 100mm.
1.
After installation, check if the connection is done correctly at the connecting points of the ground
wire, at the connector assemblies and wiring points of the circuits, as well as at each movable part
of the swing barrier turnstile. Any loose nuts, screws and other fasteners should be tightened in
time to avoid any failures caused by long-time operations.
4.
1
1 Installation Requirements
3. Make sure the ground wire of the system is reliably connected to avoid personal injuries or other
accidents.
2. It is also recommended that the swing barrier turnstile should not be used in the corrosive
environment.
The installation position of the swing barrier turnstile depends on its size. A distance of 100mm between
the swing barrier turnstile and the wall needs to be reserved for ease of opening the top cover of the
machine to perform maintenance and adjustment. The reference figure is shown below:
2 Installation Position
1947
1022
245
875
650
50 50
650
100 100
120.00
120.00 120.00

1355.00
1023.05
3 Preparation
2
To install the Mars-S1000 Series/Mars Pro-S1000 Series you must have:
4 Installation
1. Place the turnstile to the installation site.
A Screwdriver: To remove or install the screw on the device.
A Pencil: To mark the device size and the screw hole.
A Electric Drill: To drill holes according to the marked screw holes.
A Wrench: To secure the M12 expansion screw on the device.
A Tapeline: To measure the dimensions that need to be measured during the installation of the device.

4 Installation
Remove the screws fixing the top lid, and remove the top lid.
2.
3
②
①
Remove the side lid that hang on the device.
3.

4
Mark the floor following the periphery of the legs.
4.
853.00 60.00
1282 1182
913
60.00
650

Take the turnstile aside and use the electric drill according to the drawn screw holes.
5.
5
6. Clean up the soil and dust after the drilling is completed, place the turnstile to the installation site
again.
Insert the M12 expansion screw and tighten it with a wrench.
7.

8. Connect the online cables and perform the power-on test. If the test is OK, install the side lid and
top lid of the device.
6
9. It is recommended that a warning line be marked on the ground after installing the device, so as to
prompt the pedestrian to stand behind the warning line when verification.
42
1033
650
1022
245
875
100.00
120.00 120.00
M12Expansion
Screw
Tether Cable
Power Line
Ethernet
φ25mm PVC pipe

7
10. If you need to assemble the swing arm by yourself, please refer to the diagram below for
installation.
Note: The swing arm is already installed in the factory.
①
②

ZKTeco Industrial Park, No. 32, Industrial Road,
Tangxia Town, Dongguan, China.
Phone : +86 769 - 82109991
Fax : +86 755 - 89602394
www.zkteco.com