3M EPX Plus II User manual

EPX™Plus II Manual Applicator
3
2
1
1:1 2:1
To Increase
Adhesive
Bead Size
1:1
2:1
2 Load 3M™Scotch-Weld™Adhesive Duo-Pak Cartridge 3 Dispense and Discard a Small
Amount of Adhesive to Assure
Correct Ratio
1 Assemble Applicator
4 Cut for Desired Bead Size 5 Attach Mixing Nozzle 6 Apply Adhesive 7 Remove Cartridge
3
4
32
1
2
2
1
1
Plunger
62-9742-9935-6
2:1 - 62-9170-9921-0
1:1 - 62-9170-9911-1
Mixing Nozzles
Directions for Use: 1:1 and 2:1 Mix Ratio Products
62-9171-9153-8
or
34-8515-6885-6

IMPORTANT NOTICE: 3M MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. User is responsible for determining whether the 3M product is fit
for a particular purpose and suitable for user’s method of application.
LIMITATION OF REMEDIES AND LIABILITY: If the 3M product is proved to be defective, THE EXCLUSIVE REMEDY, AT 3M’S OPTION, SHALL
BE TO REFUND THE PURCHASE PRICE OF OR TO REPAIR OR REPLACE THE DEFECTIVE 3M PRODUCT. 3M shall not otherwise be liable for any
loss or damages, whether direct, indirect, special, incidental, or consequential, regardless of the legal theory asserted, including negligence, warranty, or strict
liability.
Printed in U.S.A.
© 3M 2002 34-8515-6885-6
Printed on 50% recycled
paper, including 10%
post-consumer waste.
Engineered Adhesives Division
3M Center, Building 220-7E-01
St. Paul, MN 55144-1000
1-800-364-3577 or 612-737-6501