ABB PDP32.0 User manual

—
MANUAL
PDP32.0 Profibus DP
communication module
Universal Motor Controller UMC100.3

2UNIVERSAL MOTOR CONTROLLER UMC100.3
Target group
This description is intended for the use of specialists in electrical installation and control and automation engineering who
are familiar with the applicable national standards.
Safety requirements
The responsible staff must ensure that the application or use of the products described satisfy all the requirements for
safety, including all the relevant laws, regulations, guidelines and standards.
Using this handbook
—
Symbols
This technical document contains symbols to point the reader to important information, potential risks and precautionary
information. The following symbols are used:
Indicates a potentially dangerous situation that can cause damage to the
connected devices or the environment.
Indicates important information and conditions.
Indicates a potentially dangerous situation that can cause human injuries.
—
Terms and abbreviations
 
 Universal Motor Controller
   
 
—
Related documents
Technical documentation Document no.
 
Version information
This document is valid for:
 
—
Important notice

4 Overview
5 Installation
12 Diagnosis
13 For the PROFIBUS expert
14 Technical data
17 Ordering data
3
—
Table of contents

—
Overview



supply connection


Interface


connector


connector


connector
Status
Indication
LEDs
Top View Side View













Through the communication module, you can:
• 
• 
• 
4PDP32.0 MANUAL

—
Installation
Mechanical installation


Mounting the PDP32.0 on the UMC100.3


Power
Move down PDP32.0 until
snapped-in to fix PDP32.0 on UMC100.3
—

5UNIVERSAL MOTOR CONTROLLER UMC100.3

Mounting PDP32.0 remote from the UMC100.3


is removed. Ready made cables to connect the SMK3.0 with the drawer are available, but it is also possible to use own cables.

Mounting the Single Mounting Kit

Mounting the PDP32.0/PDR31.0 on the Single Mounting Kit
  
  
and supply connectors until snapped in
Snap-in
Snapped
Snap-in


Move down
(1)
(2)
(2)
(1)
Assembly Disassembly


—

—

6PDP32.0 MANUAL

Unmounting PDP32.0/PDR31.0

—

Electrical Installation
PROFIBUS Connection



General
General cabling instructions
• Arrange the bus cables as far away from the motor cables as possible
• Avoid parallel runs
• Use bushings at cable entries
• 

X3 Description
 
 
  
 
 Isolated ground
 
 
A
 
+5 V and GND can be used for bus termination only.

X4 Description
SHLD Alternate cable shield connection. Connected to connector housing
  
A




screw driver and move the PDP32

connection.
7UNIVERSAL MOTOR CONTROLLER UMC100.3

Bus termination


PDP32.0 in a bus segment must have termination switched on.
In setups where the PDP32.0 is located in a drawer it is necessary to use an active bus termination at the end of the



Setting the bus address




Baudrate versus network length


• 
• the slowest DP subscriber sets the transfer rate of the DP line
• ≤

• number of DP subscriber ≤
• bus termination each at the beginning and the end of every DP segment necessary!
• 
9.6kBit/s
19.2kBit/s 45.45kBit/s
93,75kBit/s
187,5kBit/s
500kBit/s
1,5MBit/s
3MBit/s
6MBit/s
12MBit/s
1200
1000
400
200
100
LT/m
Transmission Speed


a result, these two variables must always be considered together.
8PDP32.0 MANUAL

PROFIBUS Line in Drawout Systems where PDP32.0 is installed on UMC100.3


LT
LT
Repeater
Last node in line: PROFIBUS termination
unit PDR31 mounted on single mounting
kit SMK3.0. 24VDC supplied
Optional connection of configura-
tion adapter
Configuration adapter UTP22
Service laptop
PROFIBUS
Master
Termination active
UMC100.3 with PROFIBUS
communication interface
PDP32 mounted in drawer
9UNIVERSAL MOTOR CONTROLLER UMC100.3

L T
L T
UMC100.3 with PROFIBUS communi-
cation interface PDP32 mounted in
non-withdrawable setup
Repeater
Repeater
Optional connection of configu-
ration adatper
Configuration adapter UTP22
Service Laptop
PROFIBUS
Master
Termination active
PROFIBUS Line in Fixed Installations



10PDP32.0 MANUAL