abc NXT 4 User manual

NXT 4
Quick Start
Guide
Starting Out
When you rst get started, this is
how your cart will look. The rest
of this guide will explain getting
from here to cleaning windows.
Attach Handle
Using tools (not included)
tighten nut on to handle bolt.
READ THIS
Read this guide before using
your system. Failure to follow
these directions voids all
warranties.
View the quick start video:
www.abcwindowsupply.com/nxt4quickstart

RO Bypass
Hose
Insert the tubing into the 1/4” tting
on the cartridges marked RO. The
output end of the Bypass Hose can
be run wherever you nd best.
Attach hose treel to pump.
Optional: you can run the system
without the pump by attaching the
hose reel directly to the bottom of
the DI Filter.
Connect your water source to
the garden hose tting on your
Carbon/Sediment lter.
Source Hose

Pole
Turn On Water
Connect your pole using the
quick connect/shut o valve
provided with your system.
Make sure the shut o valve
is in the on position.
Close your bypass valve until
only a trickle is coming out.
At least some water must be
coming out at all times while
in use.
Plug In
Plug in your cart.
Note: only follow this step if you
are planning on using the pump.

Shut Down Procedure
When you are done using your
system, fully open the bypass valve
and close the shut o valve. This
will ush your RO membranes
prolonging their life.
Do This for 1-2 minutes.
Turn o pump (if used).
Clean Windows
Enjoy your NXT system!
Turn o Water.
Turn On Pump
Turn on the pump by pushing the
on switch.
Note: ensure water is owing
through the system before turning
on the pump to avoid damaging
your pump.