abi CYRUS 100131 User manual

CYRUS WALL MO UNTE D BAS IN 50 0 X 3 0 0MM
Dis cla imer: P ro d u c ts in th is ma n u a l mu s t by la w b e in s talled b y licen s ed an d reg is tered tra d es p eo p le in a cco rd a n ce w ith th e releva n t stan d a rds . A B I a n d th e ma n u fa ctu rer/d is trib u to r
res erve t h e rig h t to va ry s p ecif ic a tio n s o r d elete mo d els fro m t h eir ra n g e w ith o u t prio r n o tif ic a t io n . Dimen s io n s a re n o min a l mea s u remen ts o n ly. Th e in f o rmatio n lis ted is co rrect at th e time
o f p u b lica tio n , h o w ever A B I a n d th e man u f a c tu rer/d is trib u to r ta kes n o res p o n s ib ility fo r p rin tin g erro rs. C o p yrig h t © A B I I n terio rs 2 02 2 Pty Ltd
SPECIFICATIONS
RECOMMENDED USE Domestic
MATERIAL Solid Surface
INSTALLATION Wall Mount, Wall or Bench Mount Spout/Mixer
Hole for bench mount to be drilled on site.
Note: Water tap hoses are not able to be concealed under basin.
OVERFLOW No
CAPACITY 5L
RIM THICKNESS 12.5mm

DO NOT use cream
cleaners or bleach.
These substances are
abrasive.
Regularly clean with
mild liquid detergent
or soap and water.
DO NOT use cleaning
pads with abrasive
surfaces as this may
scratch the material.
INSTALLATION GUIDE
This product must be installed by a licensed plumber.
This is a general installation guide - there are many factors
that are involved that can alter the installation method.
This product install must comply with AS/NZS 3500.
Note: This product must be installed by a licensed tradesperson.
This is a general installation guide - there are many factors that are
involved that can alter the installation method.
INS TA LLATION GUIDE
1Check the desired height of basin from floor. 2Fit waste and trap to basin.
3Hold basin against wall aligning outlet of
trap with waste pipe. Extend telescopic trap
up or down to find desired height & cut waste
to suit trap.
4
max 450mm C’s
structure in wall
If correct height and position is suitable, level
the top of the basin & mark out desired position.
Drill 15mm holes through the back of basin with a wood
drill bit at maximum 450mm centres. Fix basin into
structural support in wall.
5Secure plumbing to basin and wall outlet.
Test by running water through the waste.
Place the cover plate over drain. Silicone
top and sides of basin if necessary.
IN THE BOX
2 x Wall plug
2 x M8 Hanger bolt
2 x Plastic washer
2 x Metal washer
2 x Nut
1 x Basin
level