abi HENDERSON 13075 User manual

HENDERS O N WALL MO UNTE D BASIN 1 5 0 0 MM
Dis cla imer: P ro d u cts in th is ma n u a l mu s t b y law b e in s ta lled b y licen s ed a n d reg is tered tra des p eop le in a cc o rd a n c e with th e relev a n t s ta n d a rd s . A B I a n d th e ma n u factu rer/dis trib u to r
res erve t h e righ t to v a ry s pecificatio n s o r d elete mod els f ro m th eir ra n g e w ith o u t p rio r n o tifica tio n . Dimen s io n s a re n o min a l mea s u remen ts o n ly. Th e in f o rmatio n lis ted is co rrec t a t th e time
o f p u b lica tio n , h o w ever A B I a n d th e ma n u f a ct u rer/dis trib u to r ta kes n o res p o n s ibility fo r prin tin g erro rs . Co p yrig h t © A B I I n terio rs 2 02 2 P ty Ltd
SPECIFICATIONS
RECOMMENDED USE Domestic
MATERIAL Solid Surface
INSTALLATION Wall Mount, recommended with Wall Mount Spout/Mixer
OVERFLOW No
CAPACITY 28 L
RIM THICKNESS 50mm at Front and Back
100mm at Side

DO NOT use cream
cleaners or bleach.
These substances are
abrasive.
Regularly clean with
mild liquid detergent
or soap and water.
DO NOT use cleaning
pads with abrasive
surfaces as this may
scratch the material.
INSTALLATION GUIDE
This product must be installed by a licensed plumber.
This is a general installation guide - there are many factors
that are involved that can alter the installation method.
This product install must comply with AS/NZS 3500.
2Fit wastes and traps to basin.
1Check the desired height of basin from floor.
3 4
Hold basin against wall aligning outlet of trap with waste pipe.
Extend telescopic trap up or down to find desired height &
cut waste to suit trap.
the basin & mark out desired position.
Drill holes through the back of basin into structure within
Fix basin into structural support in wall. ABI takes no
5Secure plumbing to basin and wall outlet. Test by running
water through the waste. Place the cover plate over drain.
Silicon top and sides of basin if necessary. .
wall with a wood drill bit at maximum 450mm centres.
responsibility if vanity is not fixed into wall structure.
If correct height and position is suitable, level the top of
level
at max 450mm C’s
fixings into structure
fixings req.
additional
IN THE BOX
8 x Wall plug
8 x Hanger bolt
8 x Plastic washer
8 x Metal washer
8 x Nut
1 x Basin
Note: This product must be installed by a licensed tradesperson.
This is a general installation guide - there are many factors that are
involved that can alter the installation method.
INSTA LLATION GUIDE