abrasive.
structure in wall
max 450mm C’s
2Fit waste and trap to basin.
1Check the desired height of basin from floor.
34
Hold basin against wall aligning outlet of
trap with waste pipe. Extend telescopic trap
up or down to find desired height & cut waste
to suit trap.
If correct height and position is suitable, level
the top of the basin & mark out desired position.
Drill holes through the back of basin into structure within
Fix basin into structural support in wall.
5Secure plumbing to basin and wall outlet.
Test by running water through the waste.
Place the cover plate over drain.
wall with a wood drill bit at maximum 450mm centres.
IN THE BOX
Silicon top and sides of
basin if necessary.
2 x Wall Plug
2 x Hanger bolt
2 x Plastic washer
2 x Metal washer
2 x Nut
1 x Basin
Note: This product must be installed by a licensed tradesperson.
This is a general installation guide - there are many factors that are
involved that can alter the installation method.
INS TA LLATION GUIDE
Level
