Adam Equipment PTS plus Series User manual

Adam Equipment



PTS plus

Softwarerev:V1.00&above















Easy Reference:

Model name of the scale:
Serial number of the unit:
Software revision number
(Displayed when power is first turned
on
)
:
Date of Purchase:
Name of the supplier and place:



CONTENTS
P.N. 3.10.6.6.15393, Rev A, November 2019
1.0PTS PLUS SPECIFICATION ................................................................................................................. 1
2.0SAFETY ................................................................................................................................................. 1
3.0INSTALLATION ..................................................................................................................................... 5
4.0AE403 ASSEMBLY ................................................................................................................................ 6
5.0CALIBRATION ....................................................................................................................................... 9
6.0TROUBLE SHOOTING ........................................................................................................................ 10
7.0MAINTENANCE ................................................................................................................................... 11
8.0SERVICE INFORMATION ................................................................................................................... 12
WARRANTY STATEMENT ............................................................................................................................. 13



1.0 PTS PLUS SPECIFICATION

Model PTSplus 2000 PTSplus 5000a
Load cell Capacity 2000 kg 5000 Lb
Resolution 0.5 kg 1Lb
Readability 0.5kg 1lb /0.5kg
Repeatability (sd) 1kg 2lb / 1kg
Linearity 1kg 2lb / 1kg
Fork length 1150mm (45.25“) 48” (1220mm)
Fork Width (each) 160mm (6.3”) 6.3” (160mm)
Fork Width (total) 540mm (21.25”) 26.77” (680mm)
Fork Height 77mm increasing to 192mm
(3” – 7.5”)
3” – 7.5”
(77mm increasing to 192mm)
Net Weight 125 kg (275 Lb) 297 Lb (135 kg)

2.0 SAFETY
 To prevent damage to the scale, please read these operating instructions thoroughly.
 When using the pallet truck, please keep the handle in the DRIVE position.
 This pallet truck must be operated by trained personnel only.






 Check the pallet truck first before using it making sure that the wheels, handles and
forks are fitted correctly and secure
 Avoid unsuitable and uneven floor surfaces
 Please wear protective clothing where necessary
 Allow 60cm clearance from the pallet truck when operating.
 Pay attention and focus on the object you are lifting
 Do not overload.



























3.0 INSTALLATION

Please follow the installation instructions to ensure correct operation of your PTS plus. In
transportation the handle is removed from the truck, this needs to be installed following the
instructions below:
NOTE: Do not lower the handle down fully until completing the instructions below.
1) Insert the roller pin into the hole of roller rack, securing the handle to the frame
2) Fit the split pin through the holes provided.
3) Pass the chain through the center hole of the roller pin. Secure the end of the chain
to the slot on the end of the unloading plate.
4) Remove the transit rod before use. Press the handle down only far enough to
release any pressure on the transit rod, then pull the transit rod free.




4.0 AE403 ASSEMBLY









Rear view of AE 403 Indicator
Fit AE403 load cell connecting cable according to the picture below:





Fit the connecting cable to the indicator box and fix it with the 4pcs of drive pipes and 4pcs
of M6X40 socket head cap screws, tight it with the 5# Allen key provided.
Fit 7pin connector here; plug must tight to seal
it up and also prevent from getting loose,
otherwise, it will affect weighing.
AE403indicatorconnecting