ADT DSC 9047 User manual

For a detailed review of the entire system, please view the DSC 9047 system manual.
Arm and Disarm
Arm:
To arm all sensors in AWAY mode when you are leaving the premises, press and hold the [AWAY] key
for two seconds, or enter your [security code] and exit before the exit delay expires.
To arm all sensors in STAY mode without interior sensors armed, press and hold the [STAY] key for
two seconds, or enter your [security code] and do not leave the premises.
Disarm:
To disarm, enter your [security code] before the entry delay expires.
Battery
The DSC Power Series 9047 operates on the 7.2V Battery Pack.
Loss of AC power and use of backup battery power is indicated by NO AC.
A low battery condition is indicated by Low Bat.
For instructions on replacing your battery, please visit our Battery Replacement Page.
Quick Guide:
DSC 9047

Bypassing Protected Areas
Bypassing a zone allows you to arm your system with certain protected areas intentionally unarmed or to
access a protected area when the system is armed.
To bypass a zone, the function menu by pressing [*] again to reach [Zone Bypass].
Press either [1] or [*], then your [security code].
Enter the zone number to be bypassed or use the [<] [>] keys to locate the zone number + [*]
When a zone is correctly bypassed, a [B] will appear next to the zone number on the display.
Press [#] to exit.
To unbypass, repeat the bypass procedure on arm and disarm your system.
Change Date and Time
To change date and time:
Press [*] + [6] + [Master security code] + [1].
Use the [<] [>] to find the [Time and Date] menu option, then press [*] to select.
Enter the minutes and hours in 24-hour format, i.e., 16:34 for 4:45 pm.
Enter the date, months, and year in MM:DD:YY format, i.e., 082317 for August 13, 2017.
Press [#] to exit.
Chimes and Beeps
When your system is in chime mode, a chime alert will sound three tones whenever a protected door/window
is opened.
To turn chime mode on and off, hold [CHIME] for several seconds or press [*] + [4].
Reset
To clear the display after an alarm event, arm and disarm your system.
Security Codes
Your system allows for up to 16 additional users, however only the Master user can program user codes and
attributes.
To program a new user, press [*] + [5] + [Master security code].
Enter the two-digit number to be programmed, i.e., 06 for Access Code 6.
Enter the new user’s new code.
Continue adding additional user codes or press [#] to exit.
To erase an access code, press [*] + [5] [Master code] + [user access code] + [*].
Press [#] to exit.

Trouble Conditions
When a Trouble Condition is detected, the word ‘FAULT’will be displayed on the panel.
To view the Trouble Condition, press [*] + [2] and use the [<] [>] to scroll.
To silence the Trouble Condition beeps, press [#].
Volume
To adjust the buzzer volume level, press [*] + [6] + [Master code].
Use the [<] [>] keys to scroll to [Buzzer Control] and then press [*].
Once the desired volume has been selected, press [#] to save the selection.