ADT Safewatch Quick Connect Plus User manual

For a detailed review of the entire system, please view the Safewatch Quick Connect Plus system manual.
Arm and Disarm
Arm:
To arm all sensors in STAY mode when you are not leaving the premises, enter your [security code] +
[STAY] or press and hold [STAY].
To arm all sensors in AWAY mode when you are leaving the premises, enter your [security code] +
[AWAY] or press and hold [AWAY].
Disarm:
To disarm, enter your [security code] + [OFF].
Battery
The Safewatch Quick Connect operates on the 7.2V Battery Pack.
Quick Guide: Safewatch Quick Connect Plus

Loss of AC power and use of backup battery power is indicated by No AC.
A low battery condition is indicated by Low Bat.
For instructions on replacing your battery, please visit our Battery Replacement Page.
Bypassing Protected Areas
Bypassing a zone allows you to arm your system with certain protected areas intentionally unarmed or to
access a protected area when the system is armed.
To bypass a zone, enter your [security code] + [BYPASS] + [2-digit zone number].
To unbypass a zone, enter your [security code] + [OFF].
Change Time and Date
Enter your [Master code] + [FUNCTION] + [6] + [3].
When ‘SET TIME’ appears, enter the 2-digit hour, i.e., 18 for 6:00.
Press [ADD] and choose [1] for PM or [0] for AM, then press [ADD] again.
Enter the 2-digit minute, i.e., 14 for 6:14, then press [ADD].
Enter the 2-digit month, i.e., 03 for March, then press [ADD].
Enter the 2-digit day, i.e., 23 for March, 23, then press [ADD].
Enter the 2-digit year, i.e., 15 for March 23, 2015, then press ‘ADD] to accept the entry and exit Clock-
Setting mode. The keypad will beep 4 times in confirmation.
Chimes and Beeps
When your system is in chime mode, a chime will sound three beeps whenever a protected door/window is
opened.
To turn the door chime function on and off, press [FUNCTION] + [CHIME].
Reset
To clear the display after an alarm event, enter your [security code] + [OFF] to clear the alarm event history.

Security Codes
You can program up to 6 additional user codes.
To add a user, enter the [Master code] + [CODE] + [new user number] + [new user code].
To erase a user, enter the [Master code] + [CODE] + [user number] and wait approximately three
seconds for the keypad to beep and verify.
Some user numbers have already been programmed:
Pre-programmed User
Function
User Number
Installer
All functions
[1]
Master
All functions
[2]
Babysitter
Only arm the system.
[7]
Duress
Secretly notifies the
monitoring center of duress.
[8]
For a complete list of User Code Attributes, please see the Safewatch Quick Connect Plus system manual.
Trouble Conditions
When a trouble condition is detected, the word ‘FAULT’ will be displayed on the panel.
The existing Trouble Condition keyword will appear on the display.
To silence the Trouble Condition beeps, enter your [security code] + [OFF].
For a list of possible Trouble Conditions, please see the Safewatch Quick Connect Plus system manual.
Volume
System announcements and status beep volume can be adjusted.
To adjust the volume level, press [FUNCTION] + [VOLUME] + [3]/[6].
[3] increases the volume by one level and [6] decreases the volume by one level.

To mute the volume level, press [FUNCTION] + [VOLUME] + [OFF].