Advanced Bionics HARMONY User manual

Advanced Bionics
Harmony ( or Auria Harmony )
Volume dial
Typically the white dot will
be set at 12 o’clock for the
most comfortable listening
level
Program switch
Program 1: Switch right
down
Programme 2: Switch in
middle
Programme 3: Switch right
up
LED
status indicator
Gives information about the
battery, microphone and lock status
(whether the implant and processor
are communicating)

For LED symbols please see Trouble Shooting Harmony
Switching on and off
When the PowerCel (battery pack) is attached, the device is on
Removing the PowerCel turns off the device
The PowerCel slides on and off the bottom of the device
Alternative Power Sources
Harmony headpiece with attached cable
Take care inserting the cable into the connection point Align
carefully and then slide – don’t ram it in!
Earhoo s
PowerCel
slim lasts
for 14 hours
Power
Cel
Plus lasts
for 24 hours
AAA PowerPak plus
PowerCel adaptor
PSP adaptor
PowerCel charging station
Slide in PowerCel and leave
overnight or for a few hours

The earhook can be detached by turning it a little more than ¼ turn
either to the right or the left and then gently pulling it apart To put
it back on again, align the earhook in the final position and gently
push it on until it clicks
Standard earhook
To be used when the processor’s built in
microphone is the primary source for capturing
sound
T
-
Mic
earhook
For everyday use Has an omni-directional
microphone which is worn in the bowl of the ear
Particularly useful in noisy environments or on
the phone
Direct C
onnect earhook
Used to link with bodyworn radio aid receivers
and various battery powered audio devices eg
iPod, CD player You will also need to use two
cables: a Direct Connect cable (from earhook)
and an audio interface cable (to the device) For
photo, see below
iConnect earhook
There are two types of iConnect
The one at the top is the newer small iConnect
(CI-5751-120/220/320) which takes standard A10
size batteries This battery should be removed
when not in use
The bottom one is the older adult version (CI
5751-100/200/300) This requires ZeniPower
batteries which are only available from Advanced
Bionics or from Connevans
These ear hooks are for use with cable free ear
level radio aid receivers eg Phonak Microlink

MLxS, micro MLxS
and MLxi (full dynamic)
The
receiver is plugged directly into the earhook
Telecoil
There is a built in telecoil and this can be assigned to a particular
program by the clinic When using a loop system or hearing aid
compatible telephone, that program should be selected
Accessories
These can be connected by using the Direct Connect earhook and the
Direct Connect cable An audio interface cable is then used to
connect to battery powered devices such as CD players, iPods etc
A program needs to be designated for use with an external source
The Harmony Listening Chec
The Harmony Listening Check is a diagnostic tool, designed to enable
parents, carers and professionals to perform a subjective listening
test of the sound processor and accessories For more details see
the information available on Sounding Board
Need more information?
For more detailed information go to www bionicear com
A complete user guide for this product with clear details on
everything you could want to know is at
Direct Connect Cable
-
this end links
to the Direct Connect earhook
Audio Interface Cable
(above) goes in here

http://www advancedbionics com/userfiles/File/Harmony_Processor_
User_Guide_Rev_C pdf
The index at the front is very useful and will take you directly to what
you need to know
Here are some examples of information available from this user
guide:
Page
number
Attaching and removing the Accent colour pieces 8,9
Cleaning and Caring for your Harmony processor 23
Electrostatic problems 24
Direct connect cable 28
Auxiliary microphone 34
External T coil attachment 40
Using the telephone 42,43