8
USING YOUR AGELOC® LUMISPA® iO
STEP 1
• Moisten face with water.
• Apply an ample amount of ageLOC LumiSpa
treatment cleanser to all areas of the face, avoiding
eyes and lips.
STEP 2
• Wet treatment head by placing it under running
water.
• Press the Power button to start a treatment.
• Gently glide the treatment head back and forth in
slow, broad strokes over one of the areas of your face.
Note: If you use a scrubbing motion or press too hard, the
device will pause and vibrate to remind you to apply normal
pressure and resume slow, broad strokes.
• The back lights indicate the current treatment zone.
The device will pause briefly between each of the
four zones, and the lights will progress to prompt
you to move to the next area.
STEP 3
• When the treatment is done, the device will stop.
• The device will turn o automatically.
• Rinse your face with water to remove residual
treatment cleanser.
Note:
• If at any time you would like to pause your treatment, press
the Power button once. Unpause your device by pressing
the Power button again. To manually turn o the device,
press and hold the Power button.
• ageLOC LumiSpa iO is safe to use in the shower or wet
environment. However, the magnetic charger should not
be exposed to water.
• ageLOC LumiSpa iO is suitable for makeup removal.
However, do not use the device for cleansing around the
eye area. Use ageLOC LumiSpa iO Accent System for
targeting the delicate skin around the eyes.
1
2 4
3
002272_94514492-1_ageLOC_LumiSpa_iO_UserManual.indd 8002272_94514492-1_ageLOC_LumiSpa_iO_UserManual.indd 8 5/31/22 4:01 PM5/31/22 4:01 PM
