AirLive WN-250USB User manual

Table of Contents
WN-250USB User’s Manua
W
N-250USB
ireless 11b/g/n 150Mbps
le
User’s Manual
W
Mini USB Dong

Copyright & Disclaimer
WN-250USB User’s Manual 2
Copyright & Disclaimer
No part of this publication may be reproduced in any form or by any means, whether electronic,
mechanical, photocopying, or recording without the written consent of OvisLink Corp.
OvisLink Corp. has made the best effort to ensure the accuracy of the information in this user’s guide.
However, we are not liable for the inaccuracies or errors in this guide. Please use with caution. All
information is subject to change without notice
All Trademarks are properties of their respective holders.

Copyright & Disclaimer
3 WN-250USB User’s Manual
Federal Communication Commission
Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4. Consult the dealer or an experienced radio technician for help.
FCC Caution
This device and its antenna must not be co-located or operating in conjunction with any other
antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could
void the authority to operate equipment.

Copyright & Disclaimer
WN-250USB User’s Manual 4
Federal Communication Commission (FCC) Radiation Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE
C95.1-1999 and had been tested in accordance with the measurement methods and procedures
specified in OET Bulletin 65 Supplement C.
R&TTE Compliance Statement
This equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF THE EUROPEAN
PARLIAMENTAND THE COUNCIL of March 9, 1999 on radio equipment and telecommunication
terminal Equipment and the mutual recognition of their conformity (R&TTE)
The R&TTE Directive repeals and replaces in the directive 98/13/EEC (Telecommunications Terminal
Equipment and Satellite Earth Station Equipment) As ofApril 8, 2000.
Safety
This equipment is designed with the utmost care for the safety of those who install and use it.
However, special attention must be paid to the dangers of electric shock and static electricity when
working with electrical equipment. All guidelines of this and of the computer manufacture must
therefore be allowed at all times to ensure the safe use of the equipment.
EU Countries Intended for Use
The ETSI version of this device is intended for home and office use inAustria, Belgium, Denmark,
Finland, France, Germany, Greece, Ireland, Italy, Luxembourg, the Netherlands, Portugal, Spain,
Sweden, and the United Kingdom.
The ETSI version of this device is also authorized for use in EFTAmember states: Iceland,
Liechtenstein, Norway, and Switzerland.
EU Countries Not intended for use
None.
The specification is subject to change without notice.

Table of Contents
WN-250USB User’s Manua
Table of Contents
1. Introduction ........................................................................................................1
1.1. System Requirements........................................................................... 2
1.2. Package Contents................................................................................. 2
1.3. Hardware Installation ............................................................................ 3
2. Software Installation...........................................................................................4
2.1. Configuration Utility............................................................................. 10
2.2. Utility/General...................................................................................... 13
2.3. Utility/Profile........................................................................................ 14
2.4. Utility/Available Network...................................................................... 20
2.5. Utility/Status ........................................................................................ 22
2.6. Utility/Statistics.................................................................................... 23
2.7. Utility/Wi-Fi Protected Setup (WPS).................................................... 24
2.8 Software AP ........................................................................................ 29
3. Specifications...................................................................................................34
4. Frequent Asked Questions..............................................................................36
5. Wireless Network Glossary .............................................................................38

1. Introduction
1WN-250USB User’s Manual
1 1.Introduction
Thank you for purchasing the AirLive WN-250USB Wireless 11b/g/n 150Mbps Mini
USB Dongle. This ultra-compact high-speed adapter lets you connect your desktop
computer or notebook computer to a wireless network with the link speed of up to
150Mbps. This handy and mini adapter supports the latest Wireless-N technology
for greater wireless reception and enhanced the network link speed. You will soon
be able to enjoy these additional features by following the instruction in this manual.
yExtremely compact design Wireless-N USBAdapter
yAdvanced Wireless-N technology for greater wireless reception
yHi-speed data transfer rate, up to 150Mbps network link speed
yBackward compatible with IEEE 802.11b/g standards
yWi-Fi Protected Setup (WPS) simplifies the security settings
ySoftware AP function – turns wireless client into a wireless access point

1. Introduction
WN-250USB User’s Manual 2
1.1. System Requirements
yUSB 2.0 port & CD-ROM drive
yWindows XP, Vista or Windowns 7 operating system
yAt least 100MB of available disk space
Note: this device may not be able to work with USB 1.1 port
1.2. Package Contents
Before installing the adapter, please check if there’s anything missing in the package,
and contact your dealer of purchase to claim for missing items:
yWN-250USB
yQuick Setup Guide
ySoftware CD

1. Introduction
3WN-250USB User’s Manual
1.3. Hardware Installation
yUSB Connector
yConnector Cap (To protect the USB connector when not installed)
yLink/Activity LED (Green)
LED Mode Status
Flash Linked to a wireless AP / transferring dataLink/
Activity Off No link to any wireless AP / non active
With the computer switched on, insert the WN-250USB adapter into an empty USB
2.0 port.
Caution: Never use force to insert the adapter.

2. Software Installation
WN-250USB User’s Manual 4
2 2.Software Installation
1. With the WN-250USB adapter inserted and computer is powered on, the Found
New Hardware Wizard displays a screen, click “Cancel” to proceed the driver
installation.
2. Insert the enclosed software CD in the CDROM drive and click “Install Driver &
Utility” from the autorun screen. If the autorun screen did not appear, run the
“Setup.exe” program in the “Driver” folder.

2. Software Installation
5WN-250USB User’s Manual
3. When the Choose Setup Language screen displays, highlight your preference
and click “Next” to proceed.