AirLive WL-5470POE User manual

1.> Connect your internet cable to WAN port of WL-5470PoE and connect your PC to
LAN 2 via Ethernet cable .
2.> Connect the power adapter to the WL-5470PoE ’s power port.
3.> Wait about 1 ~ 2 minutes to complete the bootup procedure .
4.> Please make sure your PC’s IP is in the same subnet as theAP
(e.g 192.168.100.100 Subnet mask : 255.255.255.0) .
5.>Check whether you can ping WL-5470PoE’s IP (192.168.100.252).
If you can not ping 192.168.100.252 , please try the tips as below.
Please try to open the cmd window and input command: arp –d .
The command will clean the arp table.
Please input the command “arp –d” several times until it shows “the specified entry
was not found”, and try again.

6.>Open the web browser and enter http://192.168.100.252/.
7.>Click on “Mode“
8.>Select GW Mode in the main page
9.>Reboot device
10.>Click Setup for detail configuration
11.> Band: You can choose one mode of the following you need.
(2.4GHz (B) / 2.4GHz (G) / 2.4GHz (B+G)).
The default is 2.4GHz (B+G) mode.

12.> SSID (Network ID): Please enter your specific SSID or keep the default .
It is case-sensitive and must not exceed 32 characters.
13.>Channel Number: Please set the channel manually or keep the default .
14.>Wireless Security: Here you can configure the security of your wireless network.
WL-5470POE provides WEP, WPA-PSK (TKIP), WPA2-PSK
(AES) and WPA2-PSK (AES) security policy.
15.>WAN Port : WL-5470POE provides 4 methods for client to access the internet. This
depends on the location and the service which the ISP provides. You need to contact the
ISP for detail information.
16.> Whenever you have completed the configuration from above item(11 ~ 15),
you need to press <Apply Changes> or <Save> button to save the changed
configuration.
17.>reboot WL-5470PoE.

18.>Please set your PC or wireless client to dhcp client , it will get the IP address from
WL-5470PoE’s DHCP sever.