Allegion Schlage DEADBOLT User manual

SCHLAGE DEADBOLT
INSTALLATION INTRUCTIONS
1. SAFETY INFORMATION
Read the precautions and instructions in this manual before
installing and using this lock. Save this manual for future reference.
WARNING If the door needs to be drilled, be familiar with how to use
your drill safely and understand all the door preparation steps before
proceeding.
NOTE To ensure a long lasting nish, remove the locks, or do not install
the locks, prior to painting your door. Periodically clean locks with mild
soap and a soft cloth. Do not use abrasives or harsh chemicals and
avoid sharp or scratching objects.
2. TOOLS REQUIRED / HARDWARE INCLUDED
Part Description Quantity
AA Mounting Screws 2
BB Latch/Strike Plate Screws 4
CC Mounting Screws 2
NOTE Not to scale.
Part Description Quantity
A Key 2
B Exterior Assembly 1
C Deadbolt Latch 1
D Interior Assembly 1
E Faceplate 1
FStrike Plate 1
3. DOOR PREPARATION
NOTE If your door already has holes,
skip to step 4 for installation
3.1 Using the template over the page, mark the door, drill holes,
and chisel out a mortice. Drill from both sides to avoid wood
splitting.
3.2
Prepare the door jamb - using the strike plate
as a pattern, drill the latch and screw holes, and
chisel out a mortice until the strike plate ts ush.
To assure proper lock function, the holes in the
door jamb must be drilled 28mm deep.
25mm

4. INSTALLATION
4.1 INSTALL THE
LATCH
A) Attach the correct
faceplate
B) Set the latch backset C) Install
the latch
CAUTION Be sure the latch
cam is upright before making
any backset adjustment.
4.2 INSTALL THE CYLINDER DEADBOLT
4.3 INSTALL THE STRIKE PLATE
Allegion (New Zealand) Pty Ltd
Freephone 0800 477 869
Email [email protected]
www.allegion.co.nz
NZDBZBOLT1020 © 2019 Allegion
Single cylinder deadbolt Double cylinder deadbolt Thumbturn inside and
plain rose outside
Allegion (Australia) Pty Ltd
Freephone 1800 098 094
Email [email protected]
www.allegion.com.au