Amantii SYM XT Series Assembly instructions

Repair Guide
SYM XT Series

Content
•How to replace LED light
•How to replace flicker motor
•How to replace heating element
•How to replace the PCB board
•How to replace the signal receiver
•How to replace the canopy light
•How to replace the touch panel

Replacing the LED light
Step 1
Replace ember bed LED light
Remove the screws circled in red to remove the trim.

Magnetic stone
Trim
Please note: Magnetic stones are in place to secure the bottom of the trim to
the fireplace.

Step 2 After the trim has been removed, safely take off the front glass panel.
Front glass panel

Step 3 Remove the screws circled in red to take off the steel panel holding the
ember bed glass panel in place
The steel panels

Step 4
After the steel panels have been removed, remove the ember bed glass panel.
Please note: Lift one corner of the glass upward for easy removal of the glass.
As shown in the diagram below.

The ember bed LED strips are situated below the ember bed glass panel.

Step 5
Unbuckle the defective LED strip from the hooks that hold it in place and unplug
to replace the strip
Unplug
Unbuckle

Replacing the flame LED light
Follow steps 1 to 4 from the how to replace the Ember Bed LED light instructions,
you will then arrive here
Step 1 Remove the screws circled in red to remove the steel bar holding the
back glass and remove the back glass.

Zoomed View Zoomed View
Step 2
Remove the screws circled in red to
take off the flame effect steel panel.

HOOK
BUCKLE
Remove the defective LED strip from the hooks and unplug the buckle
to replace it with a new one.
Step 3

Follow steps 1 to 4 from the how to replace the Ember Bed LED light instructions,
you will then arrive here
.
Step 1 Remove the screws circled in red to remove the steel bar holidng the
back glass and remove the back glass.
Replacing the flicker motor

Zoomed View Zoomed View
Step 2
Remove the screws circled in red to
remove the flame effect steel template.

After the flame effect steel template has been removed, you will see the
flame motor situated on left hand side.

Step 1 Step 2 Step 3
Remove the screw
and disconnect the
motor from flicker rod.
Remove the screws
and remove the motor
from the fireplace
Take out the motor and
unplug it to insert a
new motor

Follow steps 1 to 4 from the how to replace the Ember Bed LED light instructions,
you will then arrive here
Step 1 Remove the screws circled in red to remove the steel bar holding the
back glass remove the back glass.
Replacing the heating element

Zoomed View Zoomed View
Step 2
Remove the screws circled in red to
take off the flame effect steel template

Remove the screws circled in red.
Step 3

Remove the screws circled in red to remove the inner top panel.
The heating element, PCB board, canopy light and signal
receiver are all located here
Step 4