Amart Furniture BROOKHAVEN 72570 User manual

1
ASSEMBLY INSTRUCTION
BROOKHAVEN - TALL CHEST
ITEM CODE - 72570
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
for any assistance to assembly or for missing parts please phone
Amart Furniture, Customer Service Freecall 1800 351 084
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
for any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Freecall 1800 351 084
72570
1100mm
450mm
1200mm

2
BEFORE YOU START :
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product
2. Take care when lifting. Product should be assembled as near as possible to the point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
PRE-ASSEMBLY PREPARATION
ALLOW 20 MINUTES 2 PEOPLE REQUIRED
ADDITIONAL TOOLS REQUIRED
We recommend using screw
driver to put this item together.
However if you choose to use a
power drill it must be used on
LOW SPEED (LOW TORQUE)
as too much pressure could
damage the product.
72570

372570
Step 1: Removed 20 bolts (A) with a screwdriver to take out handles
which attached inside the front of drawers.
BOLTS
M5x20: 20pcs
A

472570
Step 2: Tight 20 bolts (A) with a screwdriver again to install handles
outside the front of drawers.
A

572570
ASSEMBLY COMPLETE
DO NOT PUSH OR DRAG THIS FURNITURE - IT WILL CAUSE DAMAGE
TO THE LEG.

6
B. Wall Strap
Ø4 x 15mm 2 pcs
A. Mounting Plate
4 pcs
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach the
Mounting Plate into a stud. If mounting into brick or masonry you will need to acquire wall
anchors.
2. Attach the second Mounting Plate to the funiture frame with the Short Screws.
3. Move the funiture to its final position. Thread a Wall Strap through the both Mounting
Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and furniture and that
the Wall Strap is snug.
WALL BACK SIDE
SAFETY BRACKETS INTRUCTIONS
HARDWARE
This furniture poses a tipping risk and as such must be secured to a wall using the provided
tipping kit.
C. Large Screw
Ø5 x 40mm 4 pcs Ø4 x 20mm 4 pcs
D. Small Screw
D
B
C
A
A
72570

772570