Amphenol 957-7610 Manual

Amphenol Fiber Optic Products –2100 Western Court, Suite 300 –Lisle, IL 60532 –P [phone] –F [phone] www.amphenol-fiberoptics.com
Page 1 of 2
949-1690 Rev. B
Assembly Procedure for RJ Sealed Connectors
Procedure to be used for terminating and assembling of Amphenol Connector Kit Part Number 957-7610
Step 1: Feed CAT cable through boot and connector housing as shown below.
Note: Care should be taken not to damage the rubber sealing gasket inside the rear of the
connector housing.
Step 2: Terminate RJ-45 connector onto CAT cable
A) Strip jacketing and shield as shown
B) Fold shield back onto jacketing.
Wrap drain wire one and a half times
around the shield.
Trim excess length from drain wire
C) Untwist pairs and arrange to desired order.
Note: It is recommended to follow TIA-
568 specifications for wiring orientation
Trim conductors at an angle and insert into
the loading bar
D) Trim excess wire from holder
Insert prepared cable into RJ-45 Plug

Amphenol Fiber Optic Products –2100 Western Court, Suite 300 –Lisle, IL 60532 –P [phone] –F [phone] www.amphenol-fiberoptics.com
Page 2 of 2
949-1690 Rev. B
E) Bend strain relief to lay along cable F) Crimp plug and strain relief. Crimp tool part
number 927-2678.
Step 3: Insert terminated RJ-45 plug into connector housing
While holding the connector body, pull cable through connector housing until RJ plug is near to
the housing.
Align the plug latch with the connector housing keyway
Depress Plug latch and completely insert the RJ plug into the housing
Step 4: Attach and tighten sealing boot using a 19mm wrench
Recommended tightening torque is 5.5 to 6.0 (in-lbs) or 0.62 to 0.68 (N-m)

Mouser Electronics
Authorized Distributor
Click to View Pricing, Inventory, Delivery & Lifecycle Information:
Amphenol:
957-7610