AMTI Products SLICE 135 User manual

1. CONNECT AIRLINE, SET AT 80 PSI. 2. TURN ON SWITCH LOC. IN REAR OF
MACHINE.
4. ADJUST TOP ROLLER GUIDE WITH
MATERIAL INSERTED. MATERIAL
MUST BE CENTERED.
5. TO LOAD MATERIAL, PRESS “LOAD” BUTTON.
MATERIAL WILL INDEX AND COMPLETE ONE CUT
CYCLE.
135 QUICK START GUIDE
6. TO RUN MATERIAL, PRESS “RUN” BUTTON.
3. LOAD THE REEL SO THAT THE MATERIAL
DE-REELS FROM THE BACK AND GOES
OVER THE TOP OF THE SPRING-LOADED
TENSIONER. MINIMUM/NO TENSION AT ALL
SHOULD BE USED FOR FLEXIBLE TUBING
THAT WILL STRETCH.
*SAFETY: ALWAYS TURN OFF POWER AND DISCONNECT THE AIR LINES BEFORE
INVESTIGATING JAMS OR INTERNALS ISSUES. NEVER PLACE FINGERS, HANDS,
OR TOOLS INTO THE MACHINE WHILE IT IS PLUGGED IN OR AIR CONNECTED.

10. TO RUN, PRESS “RUN” KEY. MATERIAL WILL
THEN BEGIN DESIRED MEASURING AND CUTTING
PROCESS.
www.amtiproducts.com
847.588.7090
9. LCD WILL SHOW “COUNT” ENTER QTY. THEN
PRESS “ENTER” KEY (SEE PIC 8).
7. LCD WILL SHOW “LENGTH”, ENTER LENGTH. 8. THEN PRESS “ENTER” BUTTON.
*SEE MANUAL FOR ALL SAFETY INFORMATION