AMTI Products Slice 142 User manual

1. CONNECT AIRLINE, SET AT 80 PSI. 2. TURN ON SWITCH LOC. IN REAR OF
MACHINE.
3. ADJUST TOP INPUT GUIDE (141) WITH
MATERIAL INSERTED. MATERIAL
MUST BE CENTERED.
4. CLOSE WHEELS W/ADJUSTABLE HAND CRANK.
TOO LOOSE: MATERIAL WILL NOT BE INDEXED
AND SLIP. TOO TIGHT: MATERIAL MAY BE
CRUSHED. MAKE NOTE OF WHEEL POSITION
INDICATOR FOR FUTURE REF.
5. BOTTOM GUIDE 6. ADJUST BOTTOM GUIDE WHEEL APPROX.
¼” ON EACH SIDE OF MATERIAL
7. SLICE KEYPAD SAFETY SHEILD TO LEFT. 8. HIT “LOAD” KEY AND SLIDE KEYPAD
SAFETY SHEILD BACK TO RIGHT.
142 QUICK START GUIDE
*SAFETY: ALWAYS TURN OFF POWER AND DISCONNECT THE AIR LINES BEFORE
INVESTIGATING JAMS OR INTERNALS ISSUES. NEVER PLACE FINGERS, HANDS,
OR TOOLS INTO THE MACHINE WHILE IT IS PLUGGED IN OR AIR CONNECTED.
TOP SAFETY SHIELD
BOTTOM SAFETY SHIELD

9. FEED MATERIAL INTO THE THROAT AND PRESS
LH & RH ACTIVATION BUTTONS. MATERIAL
WILL ADVANCE FOR ONE CUT CYCLE FOR LOAD
SEQUENCE.
10. TO RUN: SLIDE KEYPAD SAFETY SHIELD TO
LEFT. PRESS “RUN”.
11. LCD WILL SHOW “LENGTH”, ENTER LENGTH. 12. PRESS “ENTER”.
13. LCD WILL SHOW “COUNT” ENTER QUANTITY.
THEN PRESS “ENTER”. 14. PRESS “RUN”. SLIDE KEYPAD
SAFETY SHIELD BACK TO RIGHT.
15. PRESS LH & RH ACTIVATION BUTTONS TO
INITIATE PROCESSING.
NOTES:
1. THE LH & RH ACTIVATION BUTTONS
ONLY NEED TO BE PRESSED ONCE AND
NOT HELD IN PLACE DURING “RUN”
CYCLE.
2. KEYPAD SAFETY SHIELD MUST BE SLID
BACK TO RIGHT HAND SIDE OF MACHINE
DUE TO SENSOR LOCATION. IF IT IS NOT,
THEN THE SLICE MACHINE WILL NOT
PROCEED WITH EITHER LOAD OR RUN
CYCLES.
www.amtiproducts.com
847.588.7090
*SEE MANUAL FOR ALL SAFETY INFORMATION