ApexDesk Little Soleil DX User manual

AFFORDABLE ADJUSTABLE DESKS FOR EVERYONE
Little Soleil DX
Children’s Adjustable Desk
Assembly Guide
REV-1609A

Table of Contents
CAUTION, USE& LIABILITY.....................................................................................................................................3
PARTS & COMPONENTS LIST...................................................................................................................................4
ASSEMBLY INSTRUCTIONS......................................................................................................................................5
CARE INSTRUCTIONS..............................................................................................................................................10
TECHNICAL SPECIFICATIONS............................................................................................................................... 10
WARRANTY INFORMATION................................................................................................................................... 11
CONTACT INFORMATION....................................................................................................................................... 11

CAUTION, USE& LIABILITY
CAUTION
Keeps small items away from small children. Keep hands off pinch points.
Do not sit or stand on the desk. Do not crawl or lie under the desk.
USE & LIABILITY
This children’s adjustable desk is designed for use in an indoor environment and dry work area only .The desk
height is adjustable so that it can be positioned at the most suitable height for your growing child. Any other
use is at user’s risk .Under no circumstance does the manufacture accept warranty claims or liability claims
for damages caused from improper use or handling of the desk.

PARTS & COMPONENTS LIST
No.
COMPONENT LIST
QTY
1
Leg
2
2
Crossbar
1
3
Crank
1
4
Top
1
5
Spindle
1
6
Drawer
1
7
Drawer panel
1
8
Shelf
1
9
Shelf holder
2
10
Phillips screwdriver
1
11
Screw A
1
12
Allen wrench
1
13
Screw B
22

ASSEMBLY INSTRUCTIONS
BEFORE YOU BEGIN
Lay out all components and hardware to ensure that you have all the parts listed on the parts page.
Contact manufacturer on Page 11 for missing parts and components.
Assemble on soft and non-abrasive surface to avoid scratch or damage to the top.
There are two types of screws needed for assembly – A and B. Only Step 4 requires Screw A. Use
Screw B for all other steps.
STEP 1
Secure legs to the desk top. Please take note of the leg and foot, and make sure the side that has crank
direction printing face outside and longer end of the foot correspond to that of the desk top.

STEP 2
Crank can be installed on either side. Take note of the spindle’s both ends. One end has hexagon rod and the
other end has tube with a small opening. Insert hexagon end to the side that crank will NOT be installed.
STEP 3
Thread crank thru the leg and into the “tube” end of spindle. There is one mounting holes on the crank.
Make sure that you can see the hole thru the opening of tube.

STEP 4
Use Screw A to secure crank to the spindle. Half-tighten the crank and make sure it turns freely before
tightening the screws fully. Slide the crank to the left or right to make adjustment if needed.
STEP 5
Secure crossbar with Screw B, two on each side.

STEP 6
Follow pre-drilled holes and assemble the drawer.
STEP 7
Follow pre-drilled holes and secure drawer to the back of the top.

STEP 8
Follow pre-drilled holes to secure shelf to the holders
STEP 9
Clamp the shelf onto the rear edge of the desk.

STEP 10
Adjust leveling studs if needed.
CARE INSTRUCTIONS
Recommend checking the screws and bolts several times a year to ensure they stay tight. Desk is intended for
use in dry, indoor areas. Avoid extended exposure to direct sunlight. For all surfaces: wipe clean with a damp
cloth and a weak cleaning solution, and then dry with a clean and dry cloth.
TECHNICAL SPECIFICATIONS
Product Dimensions
43W X 28D X 21 – 30”H
Height Adjustment Range
21-30”
Split Top Size
28W X 18”D
Split Top Tilt Angle
0-75°
Weight
64 Lbs