Argos 609/7024 User manual

Assembly Instructions -
Please keep for future reference
Dimensions
Depth - 39 cm
Width - 119 cm
Height - 34 cm
609/7031
609/7048
609/7024
New Charlie TV Unit
Important - Please read these instructions fully before starting assembly
Version 3 Date: 19/03/15
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
391/9765

1
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
Skin contact: Remove
contamination by washing with
soap and water. This procedure
should also be followed prior to
eating and drinking.
Eye contact: Rinse immediately
with clean water for 15 minutes
and seek medical advice.
If swallowed: Seek medical
advice immediately.
Glue safety - Take care when using glue, please follow the advice below
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
Handy Hints

2
front edge
Finished
Top panel (119 x 39cm)
1
Bottom panel (109.6 x 38.7cm)
2
Shelf (54 x 38.5cm)
6
Middle panel
(38.6 x 23.7cm)
5
Right side panel
(38.8 x 29.8cm)
3Left side panel
(38.8 x 29.8cm)
4
Components - Panels
Please check you have all the panels listed below
If you have damaged or missing components, call the
Customer Helpline:
Argos = 0345 6400800

3
Note: The quantities below are the correct amount to complete the assembly. in some cases mor
may be supplied than are required.
Components - Fittings
ABC
DEF
GH
30mm Dowel x 7
39mm Locking pin x 8 15mm Locking nut x 14
Feet x 1
43mm Locking pin x 6
40mm Dowel x 4
Glue x 1
50mm Screw x 3
Ruler - Use this ruler to help correctly identify the screws
Tools required
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Small
hammer
Ruler/tape
measure
Drill
Eye protection
(when using a
hammer or glue)
7mm Suitable drill bit
(for use with wall plug)
The screws length is measured from the head to the point (30mm screw shown).

Assembly Instructions
a:
b:
4
Continued on next page.
Attaching left side
panel
Screw Locking pins into
the Middle panel .
Note:
Insert Locking pins
as far as shown.
Do not over tighten.
Step 1
a: Insert Dowels into
the Middle panel &
Shelf .
D
5
6
A
5
b: Position Middle panel
56
A
D
A
5
6
6
5
D
D
C
C
Finished
front edge
onto the Shelf .
6
Use a screwdriver to turn
Locking nuts clockwise
to lock.
C
Insert 2 Locking nuts
into the
Shelf .
C
C
A

Step 2
Attaching bottom
panle
a: Insert Dowels into
the bottom panle .
D
2
Step 1 - continued
Assembly Instructions
5
c:
d:
a:
Use a screwdriver to turn
Locking nuts clockwise
to lock.
C
Insert 2 Locking nuts
into the Shelf .
6
C
E
D
D
C
C
D
EA
A
A
A
4
6
2
4
C
Finished
front edge
A
Screw Locking pins into
the Left side panel .
Note:
Insert Locking pins
as far as shown.
Do not over tighten.
c: Insert Dowels &
into the Left side panel
.
D E
4
A
4
d: Position Left side panel
onto the Shelf .
46
Continued on next page.
Finished
front edge

Assembly Instructions
6
Step 3
Attaching right side
panel
b:
c:
a:
Step
b: Position Bottom panel
onto the Left side
A
2
3
4
C
C
A
A
C
2 - continued
Finished front edge
2
4
Use a screwdriver to turn
Locking nuts clockwise
to lock.
C
Insert 2 Locking nuts
into the Bottom panel .
2
C
panel .
F
G
F
Bottom panel onto the
c:
2
2
Screw Locking pins into
the Right side panel .
Note:
Insert Locking pins
as far as shown.
Do not over tighten.
a: Insert Dowels &
into the Right side panel
D E
3
A
3
.
Continued on next page.
E
D
E
unit.
Fix Feet to Bottom
panel using Screw .
2
F
G
F
F
G
F

7
Assembly Instructions
Step 3 - continued
Step 4
2
3
1
C
C
B
B
B
B
B
B
C
b:
a: B
b: Position Right side
panel onto the Bottom
panel .
3
2
Use a screwdriver to turn
Locking nuts clockwise
to lock.
C
Insert 2 Locking nuts
into the Bottom panel .
2
C
a:
Screw Locking pins
into the Top panel .
B
1
Note:
Screw Locking pins
as far as shown.
Do not over tighten.
Attaching top panel
Continued on next page.
Finished
front edge

Assembly Instructions
8
Finishing the unit
Note: It would be useful
to ask someone to help
you at this stage.
Assembly is complete.
Step 4 -
With help, place the unit
in the intended position.
Note: Before use allow
the glue to dry for 24
hours and make sure the
unit is secure.
continued
Note:
It would be useful
to ask someone to help
you at this stage.
Use a screwdriver to turn
Locking nuts clockwise
to lock.
C
Insert 6 Locking nuts into
the unit.
Step 5
C
Carefully position Top
panel onto the unit.
b: Place a small amount
of Glue onto the joint’s
surfaces.
H
1
1
C
H
C
C
C
C
C
b:
Finished
front edge
3
4
5
H
3
4
H
5
C
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800