Argos 875/5429 User manual

4 Tier White Shoe Rack
Dimensions
Width - 75cm
Depth - 28cm
Height - 73cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
Assembly Instructions - Please keep for future reference
875/5429

1
• Check you have all the
components and tools listed on
pages 2 and 3.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Assemble the unit as close to its
final position (in the same
room) as possible.
• Assemble on a soft level surface
to avoid damaging the unit or your
floor.
• Parts of the assembly will be
easier with 2 people.
•If using power tools, please
follow the safety instructions
supplied with the tools.
• We do not
recommend the use
of power drill/ drivers
for inserting screws,
as this could damage
the unit.
Only use hand screwdrivers.
• Dispose of all packaging carefully
and responsibly.
Safety and care advice
•Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
Important - Please read these instructions fully before starting assembly

2
Net x 4
1
Side support x 2
2
PP cap x 4
32mm screw x 16
A
Allen key x 1
B
3
Components -Panels
Please check you have all the panels listed below
NOTE: The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.
Components Fittings
Please check you have all the fittings listed below
If you have damaged or missing components,
call the Customer Helpline: 08456 400800

a:
b:
Assembly Instructions
Step 1
3
NOTE: It would be useful
to ask someone to help
you at this stage.
The assembly is complete.
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
a: Inset the PP cap
into the end of Side
support .
2
2
2
3
b: Attch Screw to Side
support and Net
, and tighten by
using Allen key as
shown in fig.1 and
fig.2 .
2
2
2
2
2
2
1
11
1
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
B
A
B
fig.1 fig. 2
2
3
2
3
2
2