Argos 903/6240 User manual

DVD Storage Store 33 DVD’s
Assembly Instructions - Please keep for future reference 903/6240
Dimensions
Depth - 13cm
Width - 64cm
Height - 21cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
Version2 Date:10/09/12

Glue safety - Take care when using glue, please follow the advice below
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Care and maintenance
• Check you have all the
components and tools listed on
pages 2 and 3.
rom the
plastic bags and separate them
into their groups.
• Keep children and animals away
from the work area, small parts
could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Do not stand on the product,
this could cause damage.
• Assemble the item as close to
room) as possible.
• Assemble on a soft level surface
to avoid damaging the unit or your
r.
• Parts of the assembly will be
easier with 2 people.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
carefully and responsibly.
• Note: Only apply the glue once
you are sure of the assembly.
Skin contact: Remove
contamination by washing with
soap and water. This procedure
should also be followed prior to
eating and drinking.
Eye contact: Rinse immediately
with clean water for 15 minutes
and seek medical advice.
If swallowed: Seek medical
advice immediately.
• Only clean using a damp cloth
and mild detergent, do not use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority waste
disposal centre.
1
• Do not use this item if any
components are missing or
damaged.

2
Components - Panels
Please check you have all the panels listed below
If you have damaged or missing components,
call the Customer Helpline: 08456 400800
1Top/Bottom panel x 2 (63.6 x 13.2cm)
4Middle panel x 2 (19.1 x 11.3cm)
2Right side panel (19.1 x 13.1cm) 3Left side panel (19.1 x 13.1cm)
5Back panel (61.7 x 19.8cm)
Finished
front edge

3
Note: The quantities below are the correct amount to complete the assembly. in some cases mor
may be supplied than are required.
Components - Fittings
110 120 130 140 1500 10 20 30 40 50 60 70 80 90 100
0 1 2 3 4 5 6
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170
Tools required
Phillips screwdriver
(medium & large)
Small
hammer
Ruler/tape
measure
Eye protection
(when using a
hammer or glue)
Ruler - Use this ruler to help correctly identify the screws
ABC
D
Screw cover x 8
Glue x 1
30mm Dowel x 8 30mm Screw x 8

Use Screw covers to
4
Assembly Instructions
Step 1
Fitting dowels
Place a small amount of
Insert Dowels into the
Middle panels .
Right side panel , Left
side panel and Middle
panels onto the Top
panel .
cover the screw heads.
Glue onto the joint’s
surfaces.
D
A
4
1
B
C
X 2
2
3
A
A
A
A
1
4
4
3
2
1
2
5
A
B
B
C
C
C
C
back edge
D
back surface
4
Step 2
Attaching top panel
Step 3
Attaching back panel
5
Carefully slide the Back
panel into the unit.
Place a small amount of
Glue into the grooves.
D
D
D
4
3
D

5
Assembly Instructions
Step 4
Bottom panel onto the
unit.
Use Screw covers to
cover the screw heads.
1
B
C
Place a small amount of
Glue into the groove.
D
Attaching bottom panel
Assembly is complete.
Finishing the unit
With help, carefully stand
the unit upright and place
to intended position.
Step 5
Note:
Before use allow the
glue to dry for 24 hours
and make sure the unit is
secure.
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
5
2
C
1
back edge
D
B
3
C
C
B
C
D
1