Argos RETRO 213/3274 User manual

RETRO 3 DRAWERS COFFEE TABLE
Dimensions
Width - 105cm
Depth - 50cm
Height - 45cm
Issue 1 - 26/02/14
Important– Please read these instructions fully before starting assembly
Assembly Instructions- Please keep for future reference 213/3274

1
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
•Check you have all the
components and tools listed on
the following pages
plastic bags and separate them
into their groups.
•Keep children and animals
away from the work area, small
parts could choke if swallowed.
•Make sure you have enough
space to layout the parts before
starting.
•During assembly do not stand
or put weight on the product,
this could cause damage.
•Assemble the item as close
to its final position (in the same
room) as possible.
•Assemble on a soft level
surface to avoid damaging the
unit or your floor.
•Parts of the assembly may be
easier with 2 people.
•To reduce the
likely hood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
•Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
•From time to time check that
there are no loose screws on
this unit.
•This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
•Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
•Reguraly check andensure
that all bolts and fittings are
tightend properly.
Handy Hints
•Remore all fitting from the

Components -Panels
Please check you have all the panels listed below
2
Legs x4 (4.8x34.6cm)
2
Top Cabinet (105x50x17cm)
1
If you have damaged or missing components,
call the Customer Helpline:

3
M6x60mm Bolt x 8
Ruler - Use this ruler to help correctly identify the screws
Tools required
A
Washer x 8
B
Spring Washer x 8
C
Note:
may be supplied than are required.
Allen Key x 1
D
Components - Fittings
Ruler/tape
measure
The quantities below are the correct amount to completed the assembly. In some cases more fittings

4
Assembly Instructions
Step 1
a:
Assemble legs
a: Turn over the top
cabinet on smooth
and clean surface. Attach
legs to top cabinet
by bolts , spring
washers , washers
and Allen key . Do not
tighten the bolts.
b: Turn over the cabinet.
Tighten all bolts.
Assembly is completed.
1
b:
21
A
BC
D
1
2