ARIETE 4145 User manual

4145
Pulitore a vapore
Steam cleaner
Nettoyeuse à vapeur
Dampfreiniger
Limpiador de vapor
Limpador a vapor
Stoomreiniger





I
A
B
C
D
E
F
G
H
L
1
2
3
4
5
7
6
9
10
8
11
12
13

- 1 -
1 2
3 4
5 6
7 8

IT
-9-
EN
SYMBOLS
The information in this manual is labelled as follows:
DANGER for children
DANGER from electricity
DANGER from other causes
WARNING danger of scalds
IMPORTANT possible damage to materials
IMPORTANT SAFEGUARDS
READ THESE INSTRUCTIONS BEFORE USE.
DO NOT THROW AWAY THESE INSTRUCTIONS.
This appliance conforms to the Directives 2006/95/EC and EMC 2004/108/EC.
For disposing the appliance in an adequate manner, according to the European
Directive 2012/19/EU, please read the appropriate leaflet attached.
DANGER to children
This appliance is not suitable for use by people – including children – with reduced•
physical, sensorial or mental capabilities; by people with little or no experience or
awareness of the appliance, unless carefully supervised or trained in the use of the
appliance by a person responsible for their safety.
It is necessary to supervise children to make sure that they do not play with the•
appliance.
When disposing of the appliance as waste, it must be made inoperative by cutting•
off the power cord. Also remember to make any parts of the potentially hazard-
ous parts of the appliance safe, as there is a risk that children may use them as
playthings.

- 10 -
EN
Packaging elements must not be left in reach of children as they are potentially•
hazardous.
DANGER from electricity
Make sure that the power voltage of the appliance corresponds to that of your•
mains electricity.
Always connect the appliance to a properly earthed socket.•
In case of using extension leads, these must be suitable for the appliance power•
to avoid danger to the operator and for the safety of the environment in which the
appliance is being used. Extension leads, if not suitable, can cause operating
anomalies.
Never leave the appliance unattended when it is connected to the power mains;•
unplug it after every use.
Always switch off the appliance at the main switch and unplug it from the power•
mains before refilling it.
Make sure that hands are dry before using or adjusting the appliance switches,•
before touching the plug or power connections.
DANGER from other causes
Never leave the appliance exposed to the elements (rain, sunshine, etc.).•
Never place the appliance on or near to sources of heat.•
Make sure that the power cord does not come into contact with hot surfaces.•
Never point steam jets in the direction of people, animals or plants•
or towards appliances that contain electrical parts (e.g., oven inte-
riors).
Never direct steam jets onto the appliance itself.•
Never immerse the body of the appliance, plug or power cord in water or•
other liquids; clean them with a damp cloth.
Never use the appliance if the power cord or plug are damaged or if the appliance•
is faulty / damaged.
All repairs, including the replacement of the power cord, must only be carried out•
by an Ariete Assistance Centre or by technicians authorised by Ariete, so as to
prevent any risks.
This appliance has been designed for• domestic use only and may not be used

IT
- 11 -
EN
for commercial or industrial purposes.
During use, the appliance contains pressurised steam : improper use can be dan-•
gerous. The appliance is designed for domestic use only, as stated in the manual.
The manufacturer cannot accept any liability for damage cause through improper
or incorrect use of the appliance.
When the appliance is not in use, always lock the steam dispensing button with•
the special cursor.
WARNING danger of scalds
If the steam button is pressed before the boiler has reached the optimum tempera-•
ture, then water instead of steam could come out of the nozzle.
Never touch hot surfaces while using the product. Leave attachments to cool•
before replacing them.
Even when the appliance is not in operation, unplug it from the power mains
and leave it to cool before inserting or removing single parts or before
cleaning it.
IMPORTANT: danger of scalds
NEVER OPEN THE SAFETY CAP ON THE BOILER TANK DURING USE.
IMPORTANT: Before unscrewing the cap on the boiler tank, proceed as follows:
üswitch off the appliance at the main switch and
unplug the power cord from the mains socket;
übleed out the remaining pressure from the boiler tank,
using the steam button on the gun and
pointing the jet into a suitable container;
üleave the appliance to cool for a few minutes;
üslowly loosen the safety cap, part of the way
and wait for a few seconds;
üunscrew he safety cap completely and remove it.
IMPORTANT possible damage to materials
Before using the product, make sure that all items, surfaces and fabrics to be•
cleaned are resistant to or compatible with the high temperature of the steam.
Specifically, treated terracotta flooring, wooden surfaces or delicate fabrics, such

- 12 -
EN
as silk or velvet, should not be treated without first consulting the instructions from
the manufacturer and carrying out a test on a small hidden sample part.
Never use in swimming pools containing water.•
Never add scale removers, fragrances, alcohols or detergents to the boiler tank,•
as these could damage the appliance. We recommend filling with tap water or
alternatively, with 50% demineralised water and 50% tap water in areas where the
water is very hard.
Never use the appliance if there is no water in the boiler tank as this could damage•
the pump.
Before switching on the appliance, make sure that there is sufficient water inside•
the boiler tank (I). If it is necessary to refill the tank during use, proceed as
described previously, and following the instructions in the paragraph “FILLING
THE BOILER TANK DURING USE”.
Clean the boiler tank at least once a month so as to eliminate any scale resi-•
dues that might affect the normal operation of the appliance (see the paragraph
“CLEANING AND MAINTENANCE”).
Never use the window wiper brush if the surface to be cleaned is cold; the thermal•
movement could cause the surface to break, In cold seasons, where the tempera-
ture is particularly low, pre-heat the glass with steam jets, all over, from a distance
of about 40 cm.
When using for the first time or after a long pause, direct the steam jet into a con-•
tainer to eliminate any excess water.
Do not threaten the safety of the appliance by using parts that are not original or•
which have not been approved by the manufacturer.
Unplug the appliance by gripping the plug firmly and pulling it out of the power•
socket; never unplug the appliance by pulling on the power cord.
Any changes to this product not expressly authorised by the manufacturer may•
make safety devices inoperative and will also render the user’s warranty null and
void.

IT
- 13 -
EN
DESCRIPTION OF THE APPLIANCE
Ref. Description Ref. Description
ASteam dispenser button GON/OFF light
BLocking/unlocking cursor HON/OFF switch
CGun IBoiler
DHandle LSafety cap
EAppliance body
FSteam ready light
DESCRIPTION OF ATTACHMENTS
Ref. Description Ref. Description
①Measuring cup ⑧Window brush
②Funnel ⑨Extension tubes
③Round brush ⑩Fabric cloth
④Small round brush ⑪Fabric brush
⑤Bent nozzle ⑫Adapter with nozzle
⑥Floor brush ⑬Adapter for floor brush
⑦Floor cloth
HOW TO OPERATE
Filling the boiler tank before use
Unscrew the safety cap (L) and, using the funnel (2) supplied, pour about two measuring cups (1) of water into the boiler•
(I) (Fig. 1).
Screw the safety cap (L).•
Mount the required attachment (see paragraph “ATTACHMENTS“) to the gun (C), inserting it until it locks and pressing•
the apposite upper locking/unlocking device on the gun (Fig. 2) at the same time.
Switching on
Plug the power cord into the socket and switch on the appliance using the On/Off switch (H), Fig. 3 . The ON/OFF light•
(G) and the steam ready light (F) will turn on.
After a few minutes, the steam ready light (F) will turn off, signalling that the boiler is pressurised and the appliance can•
dispense steam.
Operation
The steam ready light (F) turns off and on during use to signal the operating pressure has been reached.•
To avoid the accidental activation of steam, move the steam locking/unlocking cursor (B) from down to up (• ). To unlock,
move the cursor (B) from up to down ( ) (Fig. 4).
For dispensing steam, press the appropriate button (A) situated on the gun (C).•
When using the appliance for the first time, direct the steam jet into a container to remove any water residue in the pipe•
(any water leakage is caused by the steam condensation inside the pipe). Repeat the above operation also after few
minutes of standstill. Anyway, when the nozzle begins to supply steam, always direct the jet toward the floor.
ATTENTION: When the appliance is not used, always lock the steam push button (A) through the apposite
stop cursor (B).

- 14 -
EN
Appliance switching off
After use, turn off the appliance by pressing the apposite switch (H) and disconnect the plug from the electrical outlet.•
Clean the attachments and the boiler following the instructions in the paragraph “CLEANING AND MAINTENANCE”.
Wrap the flexible hose around the appliance body (E) and put the gun (C) on the apposite handle (D), after having•
positioned the cursor (B) in the locking position.
ATTACHMENTS
All attachments can be used both with the gun (C) and the extension tubes (9) using the apposite adapter.
Round brush (3)and small round brush (4)
This attachment, to be fittedon the adapter (12), helps to dissolve the most stubborn encrustations, such as the ones forming
on the cooker hob top or in the grout lines between tiles. It can be used for cleaning bathroom fixtures, sinks, cooking grills,
showers or bath tubs, removing any trace of limescale (Fig. 2).
Bent nozzle (5)
This attachment, to be fitted to the adapter (12), is very useful for reaching and removing dirt in difficult areas, such as radia-
tors, shutters, and bathroom fixtures, in an easy and quick manner.
Fabric brush (11)
The fabric brush to be fitted to the adapter (12), can be used both with the gun (C) or to the extension tubes (9). By fitting
the cloth (10), it is possible to use the brush to remove dust and for the daily cleaning of sofas, armchairs, blankets, mat-
tresses and cushions (Fig. 5). The brush can also be used to freshen up fabrics, removing all creases. Anyway, when using
the appliance for the first time or during operation, it is advisable to discharge the steam condensation into a containers to
avoid wetting fabrics.
Window brush (8)
The window brush(11) can be fitted to the fabric brush. To assemble the two attachments, insert the tabs on the base of
the fabric brush into the hooks on the base of the window brush. Thanks to the window brush, windows, mirrors, and glossy
surfaces recover their brilliance. It can be used easily on glass shower cabins, avoiding the problem of the traces of limescale
(Fig. 6).
Floor brush (6)
This attachment,to be fitted to the apposite adapter (13) (Fig. 7), is used with the extension tubes (9) and features handy cloth
grips that can hold the supplied cloth (7) and any other type of machine washable cloth.
To fit the cloth, place the bush in the middle, lift the clips at the brush ends, insert an edge of the cloth and then release (Fig.
8).
Extension tubes (9)
The extension tubes snap together and can be easily separated by pressing the release device and dividing them. They are
useful for reaching high surfaces and can be used with all attachments, fixing the apposite adapter.
Nozzle adapter (12)
This attachment serves to clean thoroughly all surfaces where the most stubborn dirt settle, as well as sinks, gas stoves,
microwave ovens, hoods and all areas difficult to reach.
FILLING THE BOILER TANK DURING USE
When there is no more water in the boiler (I), turn off the appliance, disconnect the plug from the electrical outlet and
proceed as follows:
press the button (A) to discharge the residual steam.•
The safety cap (L) cannot be unscrewed until the boiler is pressurized, therefore wait a few seconds before opening the•
cap and pour water into the boiler.
Add some more water, pouring the first amount slowly to prevent steam puffs.•
Screw the safety cap (L) completely.•
Plug in appliance.•
Press the on/off switch (H).•

IT
- 15 -
EN
CLEANING AND MAINTENANCE
Emptying and cleaning the inside of the boiler tank
ATTENTION: Clean the boiler at least once a month to remove all limescale residues that could jeopardize
the proper operation of the appliance.
ATTENTION: Switch the appliance off, unplug it and allow it to cool down before proceeding with the
boiler cleaning to prevent injuries.
Exhaust the residual pressure inside the boiler (I), by pressing the steam push button (A) on the gun (C) and directing•
the jet into an appropriate container.
Screw the safety cap (L) slowly and remove it.•
Fill the boiler (I) slowly with tap water to prevent any steam puff. Shake the appliance vigorously and turn it upside down•
to empty. Repeat the above procedure several times.
ATTENTION: Never add limescale removers, vinegar or other perfumed substances into the boiler to prevent
the risk of damage of the unit and will immediately void the warranty.
TROUBLESHOOTING...
PROBLEM CHECK POSSIBLE CAUSES POSSIBLE REMEDY
The nozzle
does not dispense steam
Steam ready light (F) on Cold boiler tank Wait for the steam ready
light (F) to switch off
Steam ready light (F) off No water in the boiler
tank (I)
Refill the tank, as descri-
bed in the paragraph
“INSTRUCTIONS FOR
USE”
Steam ready light (F)
off – Water in the boiler (I) Malfunction Contact an ASSISTANCE
CENTRE
The nozzle
dispenses little steam Steam ready light (F) off Cold boiler tank Wait for the boiler tank (I)
to heat up