Asus BOXER-8222AI-B Operation manual

Most Confidential
Confidential
Internal
Public
V
NVIDIA Jetson Nano Platform
ACLinux 4.9
BOXER-8222AI-B
Nov 2020
Revision 1.0
Installation User Guide

1
Revision History
Revision
Date
Description
1.0
2020-11-05
Initial release

2
Contents
Revision History .......................................................................................1
1. Preparation .......................................................................................3
1.1. Pre-requisites..........................................................................3
1.2. On Linux Host..........................................................................4
2. To Flash Image...................................................................................5
2.1. Flash Image to Board...............................................................5

3
1.Preparation
1.1. Pre-requisites
1) Prepare an image compressed file. Its name will be like
I. {OS_IF} is OS Information; e.g. ACLNX49D which ACLNX means
ACLinux, 49 means ACLinux 4.9 and D means Desktop version
II. {PLF_IF} is Platform Information; e.g. NV03
III. {PJ_IF} is Project Information; e.g. BOXER-8222AI-B
IV. {BN} is Build Number; e.g. 0,1,2,…,N
2) Prepare one host PC which has x86 architecture
3) Install Ubuntu 16.04 or 18.04 on the host PC
4) Prepare one Jetson Nano B01 module (with eMMC)
5) Prepare one AAEON carrier board which is made for the Jetson
Nano SOM
6) Mount the Jetson Nano SOM on the carrier board
7) Prepare one microUSB cable
ACLinux_4.9_{OS_IF}.{PLF_IF}.{PJ_IF}.{BN}.tar.gz

4
1.2. On Linux Host
1) Unzip image compression file on the Ubuntu host PC
$ tar zxvf ACLinux_4.9_{OS_IF}.{PLF_IF}.{PJ_IF}.{BN}.tar.gz
2) Connect the host PC and the carrier board via the microUSB cable
3) Press and hold down the recovery button and then connect the
power supply. After 2 seconds, release the recovery button
The target board should enter recovery mode.
4) You can use lsusb command on the host PC to check whether the
device is in recovery mode or not
$ lsusb | grep 0955:7f21

5
2.To Flash Image
2.1. Flash Image to Board
1) Type [Ctrl] + [Alt] + [t] to open a terminal on the host PC
2) Enter the bootloader folder that you unzip
3) Execute script to flash image
$ sudo ./flashall.sh
4) Wait until the flashing process completes