Atlas Copco Xc1004 User manual

This Quick Start Guide helps you to get up and running in no time. However, this document does not
replace the Instruction Manual delivered with the machine. Always read the instruction manual for the
correct use, safety precautions and guidelines on preventive maintenance of your equipment.
Keep the manual with the compressor, so any operator has quick access to the document.
Starting your compressor with the Xc1004
25
5
5
76
6
24 h
1234
1
ON
OFF
12
3
1 2
4
The Xc1004 has a self-explanatory interface, with buttons that change
function as you browse through the menus. The icons in the four corners
explain the active function of every button. To access advanced
settings, press and hold the measurements button for 3 seconds.
Introducing your
Xc1004 controller
Icons in the corners
indicate the current function of
a button. Press the button for 3
seconds to access the settings menu
Pressure gauge
is always visible in the main view.
Running hours
are always visible
One additional measurement
is always visible. This changes depending
on machine features. Actual RPM, requested
RPM, vessel pressure, regulating pressure,
temperatures, etc
Alarm icons
indicates number of active alarms.
Press the button to cycle
through them.
Fuel level indicator,
only available with fuel
level sensor
Status icons
show depending on your
compressor’s features
Start button Measurement
button
Alarm button
Stop button

Icon Number Alarms
General alarm icon
1500/1521/1522 Service interval
2000 Emergency stop
2010 Coolant temperature alarm
2020 Engine oil pressure alarm
2030 Engine coolant level
2040 Compressor element temperature
3000/3010 Fuel level alarm
3050/3060 High vessel pressure alarm
3080 Vessel pressure sensor circuit
3130 Regulating pressure sensor circuit
3450/3460 Battery low/high alarm
4000/4010/4020 LP Element temperature alarm
4040 LP Element temperature sensor
circuit
Icon Number Alarms
4050/4060 Engine coolant temperature
alarm
4070 Engine coolant temperature
sensor circuit
4990 VDO sensor circuit
6309 Engine preheat failure
6327 Start failure
6420 Stop failure
6427 Run failure
7000 ECU communication error
7006 Mall function indicator lamp
7007/7008/7009 ECU red/amber/protect lamp
7020 Engine Speed alarm
7030 ECU engine coolant temperature
alarm
7040 ECU engine oil pressure alarm
7150/7160 DEF tank level 1/level 2
!
!
!
!
!
!
!
!
!
!
!
!
-+
!
!
List of most common alarm codes
In the case of an alarm or fault, your Xc1004 will
give you a orange or red banner with an alarm code
and icon.
The red banner appears in case of a shut-down,
which means the machine is stopped to protect the
operator or the compressor.
The orange banner appears in case of a warning.
This list shows you the most common alarm codes
and their meaning. If you are presented with another
code, or in case of doubt, our service technicians are
available to help out.
This screen warns the operator of an issue with
the engine coolant temperature.
Atlas Copco Power Technique
atlascopco.com/ptba
2958 2280 00 © Atlas Copco Airpower nv Belgium, Jan 2020. All rights reserved.
!