Atlas Equipment Edge 401 User manual

Unpacking your new
401/601 Atlas Alignment Machine
Congratulations on the purchase of your new Atlas Alignment
Machine. This memo is provided to get you up and going in the
fastest possible manner.
1. Your machine is ready to go out of the box. There is no need to install software, calibrate, or do
anything other than proceed with cable installation.
2. Unscrew the four screws on the front panel of the machine and four screws on the back cover of the
machine. Note: the back cover will have a ground wire attached so be careful not to pull it lose when
you set this to the side.
3. If you have a 601 model the only connections that will need to be made will be at the back of the
computer. You will plug in the usb cables, monitor cable (VGA) and power cable.
Blank CPU 601 Connected

4. If you have a 401 model it is the same except you will have one additional connector next to the
monitor cable.
401 Connected
5. On the 401 model you will notice that the cables have left and right written on the end of the cable.
Connect these according to your sensor head position. If you are unsure each head is marked on the
back with two letters. (F.L.) = front left, etc, etc. The 601 is wireless so this step will not apply on cable
connection.

6. The computer will have a disk and a flash drive in the box with it. You DO NOT need to do anything
with these items. Put them in a safe place that you know you can access them later. They will be used
only during a remote support session for memory purposes.
7. You will also receive a card. This will be inserted into the mounted card reader as shown below. This
card contains the aligner’s “identity” and database and must stay in the card reader at all times for it
to operate properly. Do Not Lose This Card!

8. The printer will be the last connection you need to make. It will be an USB cable from computer to
back of printer and a power cable from power strip (back of unit) to printer. An adapter is supplied but
not needed in most cases.
Your completed connections. You can now replace the screws on the front and rear covers and begin
enjoying your Atlas Alignment Machine!!