AV TOOL AVT-3155A User manual

AVT-3155A
PC to Video Scan Converter
Instruction Manual

Table of Contents
1.0 Introduction 2
2.0 Specifications 4
3.0 Checking Package Contents 4
4.0 Connecting the Hardware 4
5.0 Operating The Unit 6
6.0 Troubleshooting 6
7.0 Limited Warranty 6
8.0 Regulatory Compliance 7
9.0 Contact Information 8

2
1.0 INTRODUCTION
Thanks for purchasing this product from the AV Toolbox Division of TV One. The
AVT-3155A PC to Video Scan Converter is designed to convert a variety of
computer images, ranging from 640x480 to 1600x1200 pixels, to interlaced
NTSC or PAL Video. The AVT-3155A provides both Composite and S-Video
outputsignals, and is ideal for use in applications requiring the viewing of PC
images on a standard television monitor. This is but one of our complete range of
video and audio products.
1.1 Liability Statement
Every effort has been made to ensure that this product is free of errors. TV One
cannot be held liable for the use of this hardware or any direct or indirect
consequential damages arising from its use. It is the responsibility of the user of
the hardware to check that it is suitable for his/her requirements and that it is
installed correctly. All rights reserved. No parts of this manual may be
reproduced or transmitted by any form or means electronic or mechanical,
including photocopying, recording or by any information storage or retrieval
system without the written consent of the publisher.
TV One reserves the right to revise any of its hardware and software following its
policy to modify and/or improve its products where necessary or desirable. This
statement does not affect the legal rights of the user in any way.
All third party trademarks and copyrights are recognised. The TV One logo, AV
Toolbox logo, TV One-task and CORIO are the registered Trademarks of TV
One. All other trademarks are the property of their respective holders.
1.2 Features
Automatically down converts incoming PC images to NTSC or PAL.
Support high resolution PC inputs up to UXGA (1600x1200@60Hz).
Scales PC video to Composite/S-Video.
Supports both NTSC/PAL Television Standards.
Provision for Image Overscan and Underscan.
Easy to install and simple to operate.
Small, palm size footprint.

3
1.3 Getting the Best Results
There are many factors affecting the quality of results when scaling video signals.
Some basic precautions will ensure the best possible performance from your
Scan Converter.
Output display device – The quality of the output signal will depend
largely upon the type and quality of display device used. For instance,
some video projectors just look better than others.
Distance between the Scan Converter and the display device –
This plays a major role in the final result. Long distances are possible,
but special measures should be taken in order to avoid cable losses.
These include using high quality (coax-type) VGA cables. Line
amplifiers may also be necessary.
Output connection cables – Low quality cables are susceptible to
interference. They degrade signal quality due to poor matching and
cause elevated noise levels. Therefore, cables should be of the best
quality. Coax-type computer cables are recommended because of
their superior internal shielding characteristics.
Interference from nearby electrical devices – These can have an
adverse effect on signal quality. For example, an older computer
monitor often emits very high electromagnetic fields that can interfere
with the performance of video equipment in its proximity.

4
2.0 SPECIFICATIONS
Input Format Standard PC Video
Input Signal Types VGA (640x480) through UXGA (1600x1200)
Output Format S-Video (SV) or Composite Video (CV)
Output Signal Types NTSC or PAL Standard
Input Connector 1x HD-15
Output Connectors Composite Video via 1x RCA, S-Video via 1x4 Pin DIN
Device Control Auto PC resolution sensing, Manual NTSC/PAL Selection
Output Adjustments Standard Image, Overscan, Underscan
Weight 0.22lbs (100g)
Dimensions–HxWxD 0.9”x3.9”x2.5” (24x100x64mm)
Power Source 100~240VAC to 5VDC Adapter
3.0 CHECKING PACKAGE CONTENTS
Before attempting to use this unit, please check the packaging and make certain
the following items are contained in the shipping carton:
1x AVT-3155A PC to Video Scan Converter
1x 100~240VAC to 5VDC Power Adapter
1x User Manual
Note: Please retain the original packing material should the need ever arise to
return the unit. If you find any items are missing, contact your reseller or TV One
immediately. Have the Model Number, Serial Number and Invoice available for
reference when you call.
4.0 CONNECTING THE HARDWARE
The first step is to connect a PC video source to the input of the AVT-3155A
Scan Converter and then connect its output to a display device and lastly
connect the AC to DC converter. The drawings below show the locations of the
input, outputs, power switch and power connector.
The Power Switch and Power
“On” LED are located on the
top of the unit.

5
The NTSC/PAL switch on the front of the
AVT-3155A allows selection of the desired
television standard.
4.1 Connecting the Input
Before using the AVT-3155A, make certain that the PC is producing a picture on
its regular monitor. If it is, disconnect the monitor and connect an HD-15 to HD-
15 cable between the output of the PC and the input of the AVT-3155A.
If improper operation of the unit occurs and the unit has power, the most likely
cause of the problem is a PC output resolution higher than 1600x1200 or the use
of a wrong input cable.
4.2 Connecting the Output
Determine if the display you will be using accepts an S-Video input or a
Composite Video input or both. If you have a choice, you’ll want to use the S-
Video input as it will produce the best picture in most cases.
Next, position the PAL/NTSC switch to the proper position. In the United States
you will generally set the switch to the NTSC position, elsewhere you will set the
switch to PAL.
4.3 Connecting Power to the Unit
The Scan Converter is shipped with a Power Adapter to convert
100~240VAC@50-60Hz to 5VDC. Connect the DC Output Cord from the Power
Adapter to the back of the unit and then plug the Power Adapter into an AC
The input side of the AVT-
3155A is where the HD-15
PC input connector and
the 5VDC Power adapter
connectors are located.
The output side of the
AVT-3155A is where the
S-Video, Composite Video
connectors and the
Overscan/Underscan
switch are located.

6
Receptacle. When the unit’s front panel Power Switch is pressed, the Power
LED indicator will illuminate.
5.0 OPERATING THE UNIT
Once the AVT-3155A is connected to a PC and an appropriate display, apply
power and the unit will automatically detect the resolution being output by the
PC. You select the proper television standard (NTSC/PAL) and an image will
appear on the display. If you wish to make the display’s image smaller or larger,
you can move the Underscan/Overscan switch as required. There are no other
adjustments required to the AVT-3155A PC to Video Scan Converter.
6.0 TROUBLESHOOTING
Other than checking for faulty cables and for a lighted power LED, the only
common problem would be choosing a wrong television standard setting. Make
certain you have the NTSC/PAL switch set correctly. Finally, make certain that
the PC is not outputting a signal greater than 1600x1200 (UXGA) by
reconnecting your monitor and checking the PC’s output resolution on the
monitor. If it is greater than 1600x1200, readjust the output to UXGA.
After trying the above suggestions should the problem still persist, contact your
dealer for additional suggestions before contacting TV One. Should the dealer’s
technical personnel be unable to assist you, contact TV One via our support
website: http://tvone.crmdesk.com. Create a technical support request on the
site and our support team will respond within a short period of time.
7.0 LIMITED WARRANTY
LIMITED WARRANTY – With the exceptions noted in the next paragraph, AV
Toolbox warrants the original purchaser that the equipment it manufactures or
sells will be free from defects in materials and workmanship for a period of one
year from the date of purchase. Should this product, in AV Toolbox’s opinion,
prove defective within this warranty period, AV Toolbox, at its option, will repair or
replace this product without charge. Any defective parts replaced become the
property of AV Toolbox. This warranty does not apply to those products which
have been damaged due to accident, unauthorized alterations, improper repair,
modifications, inadequate maintenance and care, or use in any manner for which
the product was not originally intended.
Items integrated into AV Toolbox products that are made by other manufacturers,
notably computer hard drives and liquid crystal display panels, are limited to the
term of the warranty offered by the respective manufacturers. Such specific
warranties are available upon request to AV Toolbox. If repairs are necessary
under this warranty policy, the original purchaser must obtain a Return
Authorization Number from AV Toolbox and return the product to a location

7
designated by AV Toolbox, freight prepaid. After repairs are complete, the
product will be returned, freight prepaid.
LIMITATIONS - All products sold are "as is" and the above Limited Warranty is
in lieu of all other warranties for this product, expressed or implied, and is strictly
limited to one year from the date of purchase. AV Toolbox assumes no liability to
distributors, resellers or end-users or any third parties for any loss of use,
revenue or profit.
AV Toolbox makes no other representation of warranty as to fitness for the
purpose or merchantability or otherwise in respect of any of the products sold.
The liability of AV Toolbox with respect to any defective products will be limited to
the repair or replacement of such products. In no event shall AV Toolbox be
responsible or liable for any damage arising from the use of such defective
products whether such damages be direct, indirect, consequential or otherwise,
and whether such damages are incurred by the reseller, end-user or any third
party.
8.0 REGULATORY COMPLIANCE
The AVT-3155A has been tested for compliance with appropriate FCC and CE
rules and regulations. The Power Adaptor/Supplies have been tested for
compliance with appropriate UL, CUL, CE, PSE, GS Rules, Regulations and/or
Guidelines. These Products and Power Adapters areRoHS Compliant.
9.0 CONTACT INFORMATION
Should you have questions or require assistance with this product in areas not
covered by this manual, please contact TV One at the appropriate location.

8
AV Toolbox USA
2791 Circleport Drive
Erlanger, KY 41018
USA
Tel [phone]
Tel [phone]
Fax [phone]
[email protected]
www.avtoolbox.com
AV Toolbox Europe
Continental Approach
Westwood Industrial Estate
Margate, Kent CT9 4JG, UK
Tel [phone]
Fax [phone]
[email protected]
www.avtoolbox.com
AV Toolbox Latin America
6991 NW 82nd Avenue #8
Miami, FL 33166
USA
Tel [phone]
Fax [phone]
[email protected]
www.tvonela.com
AV Toolbox Mercosur
Av. Diaz Velez 3965 #PB
(1200) Capital Federal
Buenos Aires, Argentina
Tel [phone]
Fax [phone]
[email protected]
www.tvonela.com
AV Toolbox Asia
16F-4, No.75, Sec.1
Hsin Tai Wu Rd., Hsichih
Taipei Hsien 22101
Taiwan R.O.C.
Tel [phone]
Fax [phone]
[email protected]
www.tvoneasia.com
AV Toolbox China
Room 1007, Golden Peach Building
No. 1900 Shangcheng Road
Pudong, Shanghai
China 200120
Tel [phone]
Fax [phone]
[email protected]
www.tvoneasia.com
End of Manual