AVer MD330U Series User manual

MODE
MD330U Series PTZ Camera
User Manual

Read This First
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
WARNING
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
WARNING
この装置は、クラスＢ機器です。この装置は、住宅環境で使用することを 目的としていますが、この装
置がラジオやテレビジョン受信機に近接して使用される と、受信障害を引き起こすことがあります。
取扱説明書に従って正しい取り扱いをして下さい。
WARNING
기종별
사용자안내문
B급기기
(가정용 방송통신기자재)
이기기는 가정용(B 급)
전자파적합기기로서 주로 가정에서
사용하는 것을 목적으로 하며, 모든
지역에서 사용할 수있습니다.
WARNING
To avoid the risk of electric shock, this equipment must only be connected to a supply mains
with protective earth.
WARNING
Do not modify this equipment without authorization of the manufacturer.

CAUTION
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries in a safe and proper manner.
CAUTION
Possibly hazardous optical radiation emitted from this product. Do not stare at
operation lamp. May be harmful to the eyes.
Ce possibly c’est produit peuvent émattre les rayonnement lumineux dangereux.
Ne regarder pas directement dans la lumiere. Peut étre dangereux pour les yeux.
REMOTE CONTROL BATTERY SAFETY INFORMATION
- Store batteries in a cool and dry place.
- Do not throw away used batteries in the trash. Properly dispose of used batteries through
specially approved disposal methods.
- Remove the batteries if they are not in use for long periods of time. Battery leakage and
corrosion can damage the remote control. Dispose of batteries safely and through
approved disposal methods.
- Do not use old batteries with new batteries.
- Do not mix and use different types of batteries: alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
- Do not dispose of batteries in a fire.
- Do not attempt to short-circuit the battery terminals.
DISCLAIMER
No warranty or representation, either expressed or implied, is made with respect to the
contents of this documentation, its quality, performance, merchantability, or fitness for a
particular purpose. Information presented in this documentation has been carefully checked
for reliability; however, no responsibility is assumed for inaccuracies. The information
contained in this documentation is subject to change without notice.
In no event will AVer Information Inc. be liable for direct, indirect, special, incidental, or
consequential damages arising out of the use or inability to use this product or documentation,
even if advised of the possibility of such damages.
TRADEMARKS
“AVer” is a trademark owned by AVer Information Inc. Other trademarks used herein for
description purpose only belong to each of their companies.
COPYRIGHT
© 2022 AVer Information Inc. All rights reserved. | June 6, 2022
All rights of this object belong to AVer Information Inc. Reproduced or transmitted in any form
or by any means without the prior written permission of AVer Information Inc. is prohibited. All
information or specifications are subject to change without prior notice.
NOTICE
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE. THE
INFORMATION CONTAINED HEREIN IS TO BE CONSIDERED FOR REFERENCE ONLY.

Symbols on the product
The symbols on this product, including the accessories, represent the following.
The WEEE symbol.
This symbol indicates that this product must not be disposed of with your other
household waste. Instead, you need to dispose of the waste equipment by
handing it over to a designated collection point for the recycling of waste electrical
and electronic equipment. For more information about where to drop off your
waste equipment for recycling, please contact your household waste disposal
service or the shop where you purchased the product.
The CE compliance logo.
This logo indicates that the product conforms to the relevant guidelines/standards
for the European Union harmonization legislation.
The FCC compliance logo.
This logo indicates that the product conforms to Federal Communications
Commission compliance standards.
The UKCA (UK Conformity Assessed) symbol.
This symbol indicates that a product placed on the Great Britain market meets
the UKCA Marking requirements.
The RCM compliance logo.
This logo indicates that the product conforms with Australian RCM guidelines.
This logo is intended to alert the users to the presence of un-insulated
“dangerous voltage”within the product’s enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to persons.
This logo is intended to alert the users to the presence of important operating and
maintenance (servicing) instructions in the literature accompanying the appliance.
The China RoHS symbol.
The figure of this symbol represents the number of years during which no
hazardous substances would leak or mutate under normal conditions of use.
The ISO 7010-M002 symbol.
Refer to instruction manual/booklet.
The alternating current symbol.
This symbol indicates that the power input/output for the product is alternating
current.
The direct current symbol.
This symbol indicates that the power input/output for the product is direct current.

More Help
For FAQs, technical support, software and user manual download, please visit:
Headquarters
Download Center: https://www.aver.com/download-center
Technical Support: https://www.aver.com/technical-support
USA Branch office
Download Center: https://www.averusa.com/pro-av/support
Technical Support: https://averusa.force.com/support/s/contactsupport
Europe Branch office
Download Center: https://www.avereurope.com/download-center
Technical Support: https://www.avereurope.com/technical-support
Contact Information
Headquarters
AVer Information Inc.
https://www.aver.com
8F, No.157, Da-An Rd., Tucheng Dist., New Taipei City 23673, Taiwan
Tel: [phone]
USA Branch office
AVer Information Inc., Americas
https://www.averusa.com
668 Mission Ct., Fremont, CA94539, USA
Tel: [phone]
Toll-free: [phone]
Technical support: [e-mail]
Europe Branch office
AVer Information Europe B.V.
https://www.avereurope.com
Westblaak 134, 3012 KM, Rotterdam, The Netherlands
Tel: [phone]
Technical support: [e-mail]
Japan Branch Office
アバー・インフォメーション株式会社
https://jp.aver.com
〒160-0023 日本東京都新宿区西新宿 3-2-26 立花新宿ビル 7 階
Tel: [phone]
テクニカル・サポート: [e-mail]
Vietnam Branch Office
Công ty TNHH AVer Information (Việt Nam)
Tầng 5, 596 Nguyễn Đình Chiểu, P.3, Quận 3, Thành phốHồChíMinh 700000, Việt Nam
Tel: [phone]

Precautions for Use
AVer does not accept any responsibility for accident or damage during installation if users do
not follow the procedures described in this manual.
Indications for Use
The AVer MD330U Series is a high definition medical grade PTZ camera designed for
physicians. It’s a non-contact unit that can be operated by physicians without physical contact
with patients. The units can be used to document and update patients’ injuries by taking
snapshot images or record video clips. The unit is suitable for use in hospital examination
rooms and similar medical environments.
To installation and operation personnel
The required information including the unit’s hardware parts, operations and important notice
has been written and illustrated in this manual. Except for the information in this manual, no
special skills, training and knowledge are required for the operators. Read the installation
instructions and content of the manual thoroughly and perform the operation correctly and
safely. Please read the “Read This First!” of this manual as it contains important information.
Please also refer to the <Troubleshooting> chapter when you encounter common problems
while using this unit. For more technical support, please contact AVer’s technical support
(refer to More Help).
Warning on installation locations
This unit is for indoor use only. Do not install nor use the unit in the following locations to
avoid malfunction and/or problems in operation.
In outdoor locations where the unit will be exposed to direct sunlight.
In locations where the unit would be directly exposed to rain or water.
Extremely cold or hot locations (Operating temperatures: 0°C to +35°C; Humidity: 20%
to 80%).
On walls where the unit would be installed sideways.
At sea, in coastal areas or in locations where corrosive gases are emitted.
Locations subject to strong vibrations (this unit is not designed to be used in vehicles).
To ensure the unit perform stably over a prolonged period
Do not use this unit in a location with high temperature and humidity levels, which may
cause its parts to deteriorate and shorten its service life.
Do not subject the unit to sudden changes in temperature. Keep a cooling unit or
heating unit away from this unit.
Do not leave the unit with the camera facing the sun.
Always use the supplied power adapter and power cord to connect the unit to the
power outlet
Before installation, always disconnect the power supply of this unit.
Install this unit near the main power outlet. Ensure the power plug can be plugged into
and unplugged from the power outlet easily.
The length of the power cord is less than 3-meter.

Do not place the camera where the cord can be stepped on as this may result in fraying
or damage to the lead or the plug.
Power off the unit
This unit does not have a power switch. Disconnect the power plug from the power
outlet before proceeding with maintenance, cleaning or any emergency situations.
Cleaning
Clean the cabinet when it becomes dirty.
Before cleaning the unit, be sure to disconnect the power plug from the power outlet.
Avoid all contact with benzene, paint thinners and other volatile substances, and avoid
using these substances. Otherwise, the casing may become discolored.
Stubborn stains may be removed with a soft cloth such as a cleaning cloth lightly
dampened with mild detergent solution.
Do not use solvents such as benzene or thinner, or acid, alkaline or abrasive detergent,
or chemical cleaning cloth for cleaning the surface, as they will damage the surface.
Do not use unnecessary force to rub the surface with a stained cloth. The surface may
be scratched.
Maintenance
Designate the responsibility for keeping areas clean to staff members and clean
regularly.
This unit does not have a power switch. Disconnect the power plug from the power
outlet before proceeding with maintenance.
Regular maintenance keeps your unit productive and safe. Check all machine parts
carefully, including the removable camera head, camera body and remote control.
When the surfaces of the machine parts become dirty, follow the instructions described
in the Cleaning sector to clean the unit.
When installing, transporting or disposing of the unit
Be absolutely sure to hold it by its pedestal area at the bottom with both hands. Do not
grab the camera head, nor the camera head holder.
Dispose of the unit
When the unit is no longer going to be used, ensure to turn off the unit and dispose of it
properly.
When you dispose of the unit or accessories, you must obey the laws in the relative area
or country and the regulations in the relative hospital regarding environmental pollution.
MODE MODE
MODE
OK

Contents
Read This First........................................................................................................................2
More Help.................................................................................................................................5
Precautions for Use ................................................................................................................6
Package ...................................................................................................................................1
Package Contents................................................................................................................1
Optional Accessories............................................................................................................1
Product Introduction...............................................................................................................2
Overview..............................................................................................................................2
LED Indicators......................................................................................................................3
Pan and Tilt Angle ................................................................................................................3
Dimensions..........................................................................................................................4
Mode Switch ........................................................................................................................5
Installation............................................................................................................................6
Standalone Installation...................................................................................................6
Device Connection.........................................................................................................7
Remote Control....................................................................................................................9
Set Up the Camera ................................................................................................................10
OSD Menu.........................................................................................................................10
IPAddress Setup.........................................................................................................10
Static IP...................................................................................................10
DHCP...................................................................................................... 11
OSD Menu Tree...........................................................................................................12
Web Setup.........................................................................................................................14
Access the Web Interface of the Camera.....................................................................14
Accessing the Camera via AVer IPCam Utility..........................................14
Accessing the Camera via AVer PTZ Management..................................16
Live View .....................................................................................................................17
Camera Control.......................................................................................17
Preset......................................................................................................18
Camera Settings..........................................................................................................19
Exposure.................................................................................................19
Image Process.........................................................................................20
Video & Audio ..............................................................................................................21
Network .......................................................................................................................22
System.........................................................................................................................23
Specification..........................................................................................................................25
Troubleshooting....................................................................................................................27

Appendix................................................................................................................................28
VISCA RS-232 Command Table.........................................................................................28
VISCA over IP Settings.......................................................................................................32
CGI Command...................................................................................................................33

1
Package
Package Contents
Camera Unit
Power Adapter &
Power Cord *
Remote Control
USB 3.0 Type-B to
Type-A Cable
(1.5M)
1/4”-20 L=7.5mm
Screw (x2) **
QR Code Card
*The power cord will vary depending on the standard power outlet of the country where it is sold.
** The screws can be used for mounting the unit to a flat surface. Please refer to the <Standalone
Installation> chapter for more details.
Optional Accessories
RS-232 Adapter
(3.5mm to D-Sub 9-pin)
MODE
HOME REC SNAP
MIC PRIVACYSPEAKER
X