AVPro Edge AC-SC2-AUHD-GEN2 User manual

AC-SC2-AUHD-GEN2
Quick Start Guide
The AVPro Edge’s AC-SC2-AUHD-GEN2 is the ideal solution for integrators that are
needing to distribute a signal to a variety of displays and keep an optimal picture.
Integrators will enjoy it’s versatility of not only being able to control up/down
scaling but han¬dling EDID issues (including 4K HDR EDID’s) and being able to access
audio from the stream. This scaler is ready for future content as well as it’s able
to distribute 18Gbps signaling. Yet if you have 480, 720, or 1080 displays the AC-SC2-
AUHD-GEN2 will make sure it’s getting the right picture.
This Quick Start Guide Will be going over:
-Installation
-Control
-Output Timing
-EDID Settings
-Test Pattern
-Troubleshooting
Installation
1. Connect the SC2 Gen 2 to the power source
2. Connect the Source to the “HDMI in” on the sc2 via hdmi cable
3. Connect the display to the “HDMI Out” on the sc2 via HDMI cable
The Ultimate Toolbox: 18Gbps Signal Manager, Up/Down Scaler, EDID Manager, Audio De-Embedder

Controlling the device:
Front Pannel
Output timing, edid setttings, and test patterns can all be accessed and
controlled by the 3 buttons on the front of the sc2
Micro USb/RS232- for rmware and control
In order to connect your computer to the Scaler by rs-232 you need to make your own cable
with one end a phoenix connector and the other end a rs-232 port. Your computer doesn’t have
a rs-232 input, get a usb converter (as shown below), and plug the usb end into any computer
Output timing
The AVPro Edge’s AC-SC2-AUHD is the ideal solution for anyone that is needing to
distribute a signal to a variety of displays and keep an optimal picture. be able to
control up/down scaling and also handle EDID issues (including 4K HDR EDID’s), image
enhancement, and and the ability to de-embed 2 Channel audio from stream.
rs232 Micro usb

To control the output timing press the output setup
button until the led is lit at the corrisponding
setting numbers. if you have 480, 720, or 1080
displays the AC-SC2-AUHD will make sure it’s getting the right picture with
adaptive mode. Signals below 1080p 60Hz get upscaled to 1080p 60Hz, while
signals above 1080p 60Hz are bypassed by the scaler.
EDID SETTINGS
With EDID Settings you can manage the sources
devices and force a certain output. This is
especially important on newer sources that rely on
EDID communications in implement high bandwidth
and HDR signals. To control EDID press the EDID SEttings button until the led is
lit at the corrisponding setting numbers.
Test patterns
There are three built in Test patterns available. To Enable and Disable
press “TEST Pattern” button to cycle through the 4 resolutions.
The sc2 will output a 720P, 1080P, 4k 30Hz, and a 4k 60hz test pattern

Troubleshooting
•Verify Power - When power is applied all lights on the top of the
device will ash. You can also pressany of the 3 buttons on the
side to change settings, the corresponding lights should change
if the unitis powered up.
•Verify Connections - Make sure all connected cables are prop-
erly connected. You can use the built in Test Pattern Generator to
verify signal path from SC2 to the display
Have a question or need assistance?
Don’t hesitate to contact us!
SUPPORT: [phone]
USA TOLL FREE: 877-886-5112
EMAIL: [e-mail]