Balboa MLM990S User manual

EL/GL Series - Mach 3
MLM990S Quick Reference Guide
Initial Start-up
When your spa is first actuated, it will go into Priming
mode. Please see the M-7 Installation Instruction Manual
for complete instructions on Power-up and Pump Priming.
The Priming mode will last for up to 4 minutes and
then the spa will begin to heat and maintain the water
temperature in Standard mode. Follow the on screen
instructions. Make your choice, then press Enter ( ). If
left alone, the system will resume after 4 minutes. The
Home display screen will then appear after completion.
To Navigate : Use the buttons on the front panel to move
within the menu: Up , Left , Right , or Down .
Enter ( ) chooses your menu selection.
J1
J2
BL
LT
HT
FC
OZ
Enter
Jets 2Jets 1
LightBlower
102ºF
Setting the Time
From the Display Screen, select “Set”, then Enter ( ).
Arrow or to select “Time of Day”. Enter ( ).
Arrow or to change hour.
Arrow to select minutes. Press or to change.
Repeat to change AM/PM. To Save and Exit: .
For quick spa temperature set-up. From Home screen,
Arrow Up ; or to set temperature. to Exit.
Front Panel Buttons and Lights
For instant activation, press Jets 1, Jets 2, Blower, or Light.
The LEDs will light when activated.
Fast Keys Give Quick Access to System Set-up
Fast Keys allows you to quickly view a device and status,
and to turn it on, off, or change modes (Hi/Med/Low).
(See User’s Manual: “Fast Keys, to Program”.)
From the Home display screen, select
“Fast Keys”, then Enter ( ). The circle
represents the four directional keys.
Pressing the designated arrow key will
turn the function to Hi/Med/Low or
On/Off. Press Home ( ) to exit.
Jets 1 L
Home
98°F

900854
YXcYfX$`ejkild\ekj%Zfd
pn 40711-80_A March 16, 2007
Spa Button Menus Turn Accessories On or Off
From the Home display screen, highlight “Spa”, then Enter
(). The “Spa Functions” menu allows you to control the
following devices installed on your system: Jet Control,
Mister, Lighting, Options, and Blower.
Select and highlight a device, then press to move within
the Spa Functions/device menu with the arrow keys.
Press to turn the accessory On/Off, or High/Med/Low.
Left Arrow ( ) to exit. (Note: Devices must be set up for the
Spa buttons to function. See User Guide for set up.)
About Heat Mode
From the Home display: “Set”, , choose “Mode”, .
You can choose from Standard, Economy, or Sleep modes
when using the heater. Select the mode, then .
Standard mode maintains the desired temperature.
Economy mode heats the spa to set temperature only
during filter cycles.
Sleep mode heats the spa to within 20°F (11°C) of the set
temperature only during filter cycles.
Arrow Left to return to “Spa Settings”.
Set Menu Presets Your Equipment
Within the “Set” menu (located on the “Home” screen), you
can program your system, view diagnostic and software
information. Move within each menu with the arrow keys.
Follow the on screen instructions. to activate any menu
or device. to Exit. Options depend on devices installed.
To Program (starting from the “Home” screen).
Filter Cycles. “Home” > Set > > Filter Cycle > .
Fast Keys. “Home” > Set > > Fast Keys > .
Mode, Change Heat. “Home” > Set > > Mode > .
User Settings. “Home” > Set > > User Settings > .
Panel Settings. “Home” > Set > > Panel Settings > .
Diagnostics. “Home” > Set > > Diagnostics > .
Version(s) Info. “Home” > Set > > Versions > .
Refer to User Manual for
additional information