Baninni ARONA ISOFIX User manual

Child Safety Restraint
INSTRUCTION MANUAL OF CHILD RESTRAINT
15KG-36KG
BN2001-2
3 POINT BEL T
Itemnummer: BN2001
Imported by Unitra Int.
Voortstraat 12
2490 Balen
Belgium
Tel. [phone] - Fax. [phone]

12
For the protection of all vehicle occupants
In the case of an emergency stop or an accident, persons or objects which are
For this reason, please always check that...
*the backrests of the vehicle seats are locked (e.g. that the latch on a folding
*all heavy or sharp-edged objects in the vehicle (e.g. on the parcel shelf) are
*all persons in the vehicle have their seatbelts fastened.
*the child safety seat is always secured in the car via a 3-point belt , even when
.
For the protection of your child
*The more snug the harness fits over your child's body, the safer your child
*Please do not ever leave your child unattended in the child safety seat in the
*Use on the rear seat:
Move the front seat forward far enough that you child's feet cannot hit the
*The child safety seat can get hot in direct sunshine. Caution: Children's skin
*Only allow your child to enter and exit the vehicle on the pavement side.
*Make stops during longer journeys to give your child an opportunity to run
To protect your vehicle
Some vehicle seat coverings made of more delicate materials (e.g. velour,
For optimum protection of your seat covers, we recommend using LB/BBC Car
.
Read this instruction manual carefully before use and save it for future
reference in the pocket provided on the backrest of the child safety seat.
serious injury to your child .
not properly secured in the car can cause injury to other vehicle occupants.
rear seat bench is engaged).
secured.
there is no child in the seat.
will be.
vehicle.
backrest of the front seat (to prevent risk of injury).
is delicate and could be injured as a result. Protect the child seat against
intensive direct sunlight when it is not currently in use.
about and play.
leather, etc.) may develop wear marks when child seats are used.
Seat Protector, which is available from our of accessories
Failure to follow the instructions contained in this manual could result in
*Always make sure that any straps holding the seat restraint to the vehicle shall be
tight , and check that the straps shall not be twisted.
*It is dangerous to make any alteration or additions to the device without the approval
of the competent authority, and a danger of not following closely the installation
instructions provided by the child restraint manufacturer.
*The child restraint must not be used without the cover .The seat cover should not be
replaced with any other than the one recommended by the manufacturer, because
the cover constitutes an integral part of the restraint performance.
*For easy fix installation: Make sure you read the car manufacturer’s handbook.
.
*This instruction manual can be retained in the special space of the child seat for its
.
life period
*Do not use any load bearing contact points other than those described in the
instructions and marked in the child restraint.
NOTICE:
1.This is a “Universal” child restraint when be used without connection with
may only be used in certain types of vehicles.
ISOFIX anchorage. It is approved to Regulation No.44,04 series of amendments,
3.The mass group is: group 2+3 (15 to 36kg).
4.If in doubt, consult either the child restraint manufacturer or the retailer.
anchorage), the child seat fall into the “Semi-universal” admission category. It
for general use in vehicles and it will fit most ,but not all, car seats.
2.When installing the LB-526B with easy- fix system(connection with ISOFIX

34
Easy Fix Attachment
Instruction Bag
Easy Fix Releasing Button and Indicator
H
D
E
FC
G
A
B
Headrest
Backrest
Base
Easy Fix lever
Easy Fix Adjuster
A
B
C
D
E
I
Easy Fix locking arms
G
F
F
H
I
J
JAdjustment handle
K
KBelt guide

56
child safety seat
Tested and certified according
to ECE* R 44/04
Group
are located on the orange certifcation sticker (sticker on the child
this certification will be invalidated if you make any modifcations to
The child safety seat must only be used to secure your child in the
body weight
LB/BBC526B 15KG-36KGII&III
The child safety seat has been designed, tested and certified according
to the requirements of the European Standard for Child Safety Equipment
(ECE R 44/04). The test mark E (in a circle) and the certifcation number
safety seat).
the child safety seat.
vehicle. It must never be used as a seat or toy in the home.
*ECE = European Standard for Child safety Equipment
To ensure the full protective effect of the child safety seat:
*In the event of an accident with an impact speed above 10
km/h it is possible that the child safety seat may have been
damaged, but that the damage may not be immediately
obvious. In this case the child safety seat must be replaced.
Please dispose of it properly.
*Regularly check all important parts for damage. Make sure
that the mechanical components in particular are all in per-
fect working order.
*To prevent damage, ensure that the child safety seat does
not become jammed between hard objects (car door, seat
runners etc.).
*Always have the child safety seat checked if it has been
damaged (e.g. if it is dropped).
*Never lubricate or oil parts of the child seat.
Please observe the waste disposal regulations in your country.
Disposal of packaging Container for cardboard
Cover Residual waste, thermal utilisation
Plastic parts In accordance with the labelling in
designated containerthe
Metal parts Container for metals

78
This is how you can use your child safety seat:
forward facing yes
rearward facing no 1)
installed with 2-point belt no
installed with 3-point belt yes 2)
on front passenger seat yes 3)
on outer rear seat yes
on centre rear seat (with 3- yes 4)point
belt )
(Please observe the relevant regulations in your
country.)
1) Use is permitted on a rearward-facing vehicle seat
(e.g. in a van or minibus) only if the vehicle seat is
also approved for use by adults. The seat may not be
in the area of effect of an airbag.
2) The safety belt must be approved to ECE R16 or a
comparable standard (see test label on belt with an "E"
label onbelt with an "E" or "e" in a circle).
3) If there is a front airbag: slide back all the way or nearly
so, observe any instructions in vehicle owner's manual.
4) Cannot be used if the vehicle seat is equipped with
only a 2-point belt.
Danger! Should your child be secured in the
vehicle seat with only a 2-point belt, he or she
in death.
Never use in connection with a 2-point belt !
could sustain serious injuries possibly resulting

910
1
distribution of the diagonal belt section and provides
your child with the desired protection and comfort. You
can adjust the height of the headrest to several positions.
B. The headrest must be adjusted in such a way that you
can still pass one finger between the your child's shoulders
and the headrest .
C. To adjust the height of the headrest to fit your child：
Grasp the adjustment handle by the back of the headrest
and pull it upwards. The headrest is now released.
D. You can now adjust the released headrest to the desired
height. As soon as you have let go of the adjustment handle,
the headrest will engage.
A. A properly adjusted headrest ensures the optimum
A
J
E.
Pull the instruction bag
upward and make sure the
G
bag fall.instruction doesn’t
2

11 12
3
F. Place the child safety seat facing in the direction of
travel on the vehicle seat.
G.Have your child sit down in the child seat and check the
height.
C aution! Repeat this process until the headrest is at the
optimal height.
4

13 14
w ith the vehicle seat belt.
H. Pull out the vehicle seat belt and guide it in front of your
c hild to the vehicle seat buckle. Your child is simply secured
Caution! Do not twist the belt. Engage the buckle tongue
in the vehicle seat buckle.
Inserting the vehicle seat belt into the right belt guide
of the child seat as the picture show.
Caution! The lap belt section must lie as low as possible
over your child's hips.
K
5
NOTE! If the vehicle seat is fitted with the ISOFIX anchorages,
you can connect the child seat with the ISOFIX anchorages of
the vehicle seat using the easy fix, your child will still be buckled
up using the 3 point belt.
I. Pull the easy fix lever to pull out both locking arms
until the locking arms to the end of the site.
D
please make sure easy
unlock. fix releasing button is H
6

15 16
CLICK!
J.Grasp the child safety seat with both hands and slide
Caution: The locking arms are
only correctly engaged if both of the easy fix indica-
the two easy fix locking arms firmly into the insert
I
car seat guides until the locking arms engage with a
clicking noise on both sides.
tors are completely green.
7
H
CLICK!
K.Push the child safety Pull the ,seat witheasy fix lever
a back as it will go.substantial amount of force as far
L.Shake the child safety seat to make sure it is safely
8
attached and re-check to the easy fix releasing
buttons and indicators are completely green.
H
D
M. Now, you can place your child in the child seat and secure
your child. Please repeat the process in H.

17 18
European safety child seat is sweeping the whole world now
European satety standard
Washing instruction:
Open the fastener on the fabric cover and remove the cover.
If you are in doubt using or fitting of this product or you
require any replacement parts,please contact your store.
about