BEINAT CHECKER-24 User manual

You can get it for free
with the purchase of 20 sensors !!
Are you sure to have correctly performed the GAS
sensors connection?
Today withCHECKER-24 you can do it !!
Are you sure the GAS sensors detection are working
well?
TodaywithCHECKER-24 you can perform the check !!
CHECKER-24
CHECKER-24
GAS SENSOR controller
Belonging to

1) Insert the terminal connected to the probe cable from
the control unit. Insert it in the right position
Made in Italy
Commerciale - [e-mail]
[e-mail]
CHECKER-Rev-1 18 18
BEINATS.r.l.
Via Fatebenefratelli 122/C 10077, S. Maurizio C/se (TO) - ITALY
Tel. [phone] - Fax [phone]
http:// www.beinat.com
2) Press and hold the button after inserting.
If the Green LED lights up, the cable connection is EXACT.
At the same time the control unit will exit the state of Fault
and signal the status of ALARM.
OPERATING:REGULAR
3) Press and hold the button after inserting.
If the RedLEDlights up, the cable connections areWRONG.
Check the connection and try again
The control unit does not report any status of ALARM, but
indicates the status of FAULT.
OPERATION: NOTREGULAR.